Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Bathroom Remodeling: The Antioch Owner’s Guide
Tamko bathroom remodeling in Antioch typically runs $9,000 – $28,000 installed, depending on whether you’re handling a shower-only replacement or a full gut of a 1950s ranch bath in the A Street corridor. Small bath remodels land in the $5,000 – $12,000 range when we’re keeping the footprint and reusing the tub. We schedule free estimates seven days out, and calls are answered by a live person around the clock, not a voicemail box.
Owners usually find out something’s wrong the same way: a soft spot under the bath mat that wasn’t there last spring. Or a tile that pops loose because the substrate got wet from a failed shower pan. Or a grout line that keeps cracking every six months no matter how many times it’s patched. By the time you’re reading this, you’ve probably already stuck a level on the floor and found it out of whack by a quarter inch. That’s the signal.
Which Tamko Models This Applies To
Tamko’s residential bathroom lines show up most often in Antioch homes built between 1998 and 2015, where the original builder used Tamko’s waterproofing membrane under tile and their shower-pan systems in tract-built master baths. The most common installs we see are the Tamko TileGuard and EverGrip membrane systems paired with a Tamko prefab pan. Labels are usually stapled to the subfloor edge or inside the plumbing wall cavity next to the drain. Take a photo of the label before demolition – matching the membrane weight and pan dimensions to the existing drain location is where most remodelers get it wrong and end up reframing.
On the OEM-versus-aftermarket question: Tamko’s own replacement pans and membranes are dimensional matches, so the drain alignment and slope are guaranteed. Aftermarket equivalents from Nobel or Schluter can work, but they run 1/8″ to 1/4″ off in pan thickness, which means re-floating the floor to match the original drain height. We quote both paths on every estimate so you can see the difference in writing. For vanity and countertop upgrades, we also install KraftMaid, Cambria, and Silestone under the same upfront pricing.
One reality worth flagging: Tamko membranes in Contra Costa County typically last 15 to 20 years before the adhesive bond degrades. Antioch’s triple-digit summer heat cycling against a bathroom that’s 20 degrees cooler inside accelerates that. If your membrane is past 18 years, replacement beats repair every time.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Bathroom Remodeling Is Failing
- Soft or springy floor near the shower drain. Water is getting past the membrane and soaking into the subfloor. In Antioch homes we see this most often in second-floor baths where the pan slope was set too flat at original install.
- Grout lines that crack repeatedly in the same spot. The substrate underneath is moving, which means either the cement board wasn’t fastened to spec or moisture has swelled the subfloor.
- Musty smell that lingers after cleaning. Trapped moisture in the wall cavity, usually behind the shower surround. This one is a mold concern, not a cosmetic issue, and shouldn’t wait.
- Tiles popping loose or hollow-sounding underfoot. The thinset has separated from the membrane or the board. Walking on them can crack tiles and drive repair cost up.
- Water staining on the ceiling below the bathroom. The pan or drain seal has failed. This is the point where a $3,000 shower replacement becomes a $12,000 full bath remodel if you wait another season.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Tamko-compatible bathroom remodeling costs in Antioch, with parts and labor broken out so the numbers actually mean something:
| Scope | Installed Range |
|---|---|
| Small bathroom remodel (keep footprint) | $5,000 – $12,000 |
| Shower replacement | $3,000 – $8,500 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Bathroom vanity installation | $800 – $3,000 |
| Full bathroom remodel | $9,000 – $28,000 |
What drives the range: whether we’re matching an existing Tamko pan (cheaper) or re-framing the drain location to fit a new one (adds $1,200 to $2,800 in labor). Tile selection matters too – a porcelain floor and shower combo runs less than a full slab-marble surround. Every estimate is written line-item, and your number doesn’t move once we start. All work is backed by our 730-Day Done Right Promise, and permits are pulled and inspections passed before we call the job done.
DIY or Call Us?
What you can safely check yourself: lift the drain strainer and look at the pan surface for standing water, run your hand along the base of the tile at the shower wall for soft caulk or movement, and check the ceiling below for staining. Those three checks tell you whether it’s a $200 caulk-and-seal job or a membrane replacement.
Where DIY goes wrong: pulling the drain assembly on a Tamko pan without the right wrench strips the clamping ring, and now you’re cutting out the pan from underneath. Chipping out tile to “see what’s going on” almost always cracks the surrounding tiles and drives the repair cost up by $1,500 or more. Once you’re past caulk, call (888) 419-3650. We’ll send a licensed technician, we install any Tamko-compatible components or aftermarket matches with no surprises, and your estimate is free.
FAQs
15 to 20 years in Antioch’s climate. Heat cycling between a hot attic chase and a cooler bathroom shortens it, so second-floor master baths here tend to fail closer to 15. If your home was built before 2010 and the membrane’s original, it’s on borrowed time. Call (888) 419-3650 for an inspection quote.
Yes, if the failure is limited to a cracked tile or a worn caulk line, and often for under $500. Once the membrane is compromised or the pan is cracked, repair doesn’t hold and replacement is the honest answer. We’ll tell you which one it is in the estimate.
A shower or pan replacement takes 2 to 4 days once materials are on-site. A full bathroom remodel takes 2 to 3 weeks depending on scope and inspection scheduling. We give you a written timeline and hit it, or we answer for it under the promise.
Through authorized distributors, matched by model label and measurement, not by “close enough.” We don’t carry parts on a truck or claim to stock them locally – we spec them, order them, and have them on-site before demo starts so your bathroom isn’t torn open waiting on a shipment. The goal is one trip, one install, no return-visit surprises. For exact pricing on your model, call (888) 419-3650 – estimates are free and no-hassle upfront.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.