Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Home Additions & ADU: The Antioch Owner’s Guide
If you’re planning a home addition or ADU in Antioch and your builder specified Tamko roofing and waterproofing systems for the structure, we install those systems – a finished addition in Antioch typically runs $45,000 – $130,000, and an ADU runs $90,000 – $220,000. Tamko’s Heritage shingles, TileSeal underlayment and waterproofing membranes are what protect the new space from the Delta’s winter rain and summer heat, so getting the material spec right at the front end matters more than most owners realize. This page covers the Tamko system components we work with, the signs something has failed or was installed wrong, and what honest pricing looks like in Antioch.
Owners usually start investigating after a wet winter. A ceiling stain in the new room, shingles lifting along the valley where the addition ties into the original roof, or a cold draft at the tie-in point all point to the same short list of causes. We walk you through them below.
Key Takeaways
- A Tamko-specified addition in Antioch typically runs $45,000 – $130,000; an ADU runs $90,000 – $220,000.
- The tie-in between new construction and your existing roof is where most Tamko systems fail first.
- Tamko Heritage shingles carry a manufacturer warranty, but workmanship on the install is separate – and that’s where the real protection lives.
- We’re an independent contractor, not affiliated with Tamko, and we’ll tell you honestly whether a repair or a replacement is the right call.
Which Tamko Models This Applies To
Tamko makes a range of roofing and waterproofing products that come up on additions and ADUs in Antioch. On the roof side, the most common lines we see specified are Heritage architectural shingles (the standard for most residential additions), Titan XT for its impact rating, and MetalWorks steel for owners who want a longer service life or a specific look. Underneath, TileSeal and Tamko’s underlayment products handle the waterproofing layer that does much of the actual work in wet weather. For flat or low-slope sections – common on ADU carport tie-ins and bedroom bump-outs – Tamko’s modified bitumen membranes come into play.
To identify what’s actually on your structure, check the plans and permit documents first (Antioch requires permits for both additions and ADUs, and the spec sheet usually names the product). If those are gone, look at the bundle wrapper in the attic, measure a shingle tab width, or check for the Tamko name stamped on the underside of an exposed shingle at a gable edge. On the OEM-versus-aftermarket question: for shingles, matching the exact Tamko line matters because mixing profiles on a small repair shows in the roof plane and can complicate the manufacturer warranty. For underlayment and membranes, a quality equivalent is often fine if the spec allows it. We confirm both before anyone orders material.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Home Additions & ADU Is Failing
These are the symptoms we actually find on Antioch additions and ADUs, and what’s usually behind them.
- Ceiling stains in the new room. Water is getting past the roof-to-wall tie-in or a valley flashing. On additions, the junction between new and old roof is the number one leak source, and a Tamko underlayment that was lapped wrong will let water track under the shingles instead of shedding it.
- Shingles lifting or curling along an edge. Heat and the Delta wind cycle work on shingles that weren’t sealed down properly. Curling at a rake or ridge points to either inadequate fastener placement or a venting problem in the new roof assembly.
- Granules collecting in the gutter or at downspout outlets. Some granule loss is normal in the first year. Heavy loss after that means the shingle is aging faster than it should, often from poor attic ventilation in a tightly built addition.
- Drafts or moisture at the wall-to-roof intersection. This is usually a flashing and sealant failure, not the shingle itself. The Tamko membrane or flashing detail at the transition has opened up and needs to be redone properly, not just caulked over.
- Soft spots or sagging in the new roof deck. This one is serious. It can mean water has been getting in for a while, or that the structural framing under the addition wasn’t sized for the load. It needs eyes on it before anything else happens.
One reality about the Antioch climate: our wet winters concentrate the leaks into a few months, so a slow intrusion that started in spring shows up all at once in December. If you see a stain in January, the water has likely been getting in since the previous rainy season.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Full home additions in Antioch run $45,000 – $130,000, and ADU construction runs $90,000 – $220,000. Those ranges include the Tamko roofing system as part of the full scope, not as a separate line. Where a Tamko component has failed and needs replacement on an existing structure, the cost depends on the extent:
| Scope | Typical Antioch range |
|---|---|
| Full home addition (including Tamko roof system) | $45,000 – $130,000 |
| ADU construction (including Tamko roof system) | $90,000 – $220,000 |
| Localized roof system repair on an addition | $400 – $1,800 |
| Larger roof section replacement tied to a failed tie-in | $8,000 – $20,000 |
What drives the range: square footage, whether the foundation needs work, the roof complexity (a simple gable is cheaper than multiple valleys and tie-ins), and permits – Antioch requires them for both additions and ADUs, and we pull them and pass inspection rather than leaving that to you.
Every project we do is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers the workmanship, which is the part the manufacturer warranty doesn’t. Pricing is upfront and the number you see is the number you pay – no change-order surprises. We also offer 0% financing for 18 months and $1,000 off projects over $10,000, which helps on a project of this size.
DIY or Call Us?
Some checks are safe to do yourself. You can look in the attic for daylight or water staining after a storm, check the plans for the specified Tamko product, and clear debris from gutters and valleys. Those are useful observations that help us diagnose faster.
Where DIY goes wrong on a Tamko roof system: the tie-in flashing and membrane work. Reroofing a section, lapping underlayment correctly, and flashing a roof-to-wall junction are not weekend skills, and a bad repair can void the manufacturer warranty and drive water deeper into the addition’s framing before you notice. This isn’t a part you swap – it’s a system detail that has to be built right. If you’re seeing repeated leaks or a sagging deck, don’t climb up there. Call us and we’ll look at it properly.
Our technicians have up to 12 years of experience, they’re background-checked and arrive in uniform, and calls are answered by a live person 24/7. Call (888) 419-3650 to schedule your free estimate.
FAQs
How long does a Tamko roof system last on an Antioch addition?
A properly installed Tamko Heritage roof typically lasts 20 to 30 years in our climate, but the Delta’s summer heat and winter rain stress the tie-in details faster than the shingles themselves. The shingles usually outlast the flashing and membrane work at the junction, which is why that’s where we look first on any addition.
Can the Tamko component be repaired instead of replaced?
Often, yes. A localized leak at a valley or tie-in can frequently be repaired without touching the full roof, which is why we diagnose before we quote. When the failure is widespread granule loss or a compromised underlayment across the whole roof plane, replacement is the honest answer. We’ll tell you which one applies to your structure. Call (888) 419-3650 for an exact quote – estimates are free.
How long does a repair take?
A localized repair on an addition or ADU roof typically takes a day; a larger section replacement usually takes two to three days depending on weather and access. We give you a realistic window at the estimate, not a promise we can’t keep. Call (888) 419-3650 to get on the schedule.
How do you source the Tamko product?
We source Tamko products through the supply chain as part of the project scope – we don’t keep parts on hand or carry inventory. We confirm the exact Tamko line and profile against your plans or the existing roof before ordering, so the new materials match the system correctly. Call (888) 419-3650 to talk through your project.
We also work with KraftMaid, Cambria and Silestone on the interior side of additions, so the whole project runs under one contractor from foundation to finish line. We’re an independent contractor and not affiliated with Tamko – we simply install the systems builders and architects specify, and we back the work in writing.
Ready to price your Antioch addition or ADU project? Call (888) 419-3650 for a free estimate and design consult. Live person, 24/7. Upfront pricing, no surprises.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.