Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Antioch Owner’s Guide
Boral fence installation in Antioch typically runs $3,500 – $9,000 installed, depending on linear footage, fence height, and the style you choose from Boral’s composite and stone-look lines. Boral doesn’t make fence panels the way it makes brick and siding, so what most Antioch homeowners are really after is a composite or masonry-style fence finished to match a Boral product already on the house. That’s work we do regularly, and the 730-Day Done Right Promise covers every inch of it.
Owners usually call us after a wind event or a wet winter. A post leans. A panel stays bowed after the ground dries. Or the color has gone chalky on a fence that was sold as never needing anything but a rinse. If that sounds familiar, you’re in the right place.
Key takeaways:
- Installed Boral-compatible fence in Antioch: $3,500 – $9,000.
- We’re an independent installer, not affiliated with Boral.
- Fence quotes are line-item and fixed. The number you see is the number you pay.
- Free estimate and design consult. Call (888) 419-3650.
Which Boral Models This Applies To
Start with the match to the house, not the fence catalog. Boral is best known in Antioch for brick, manufactured stone veneer, and its composite siding and trim lines. When someone asks us for a “Boral fence,” nine times out of ten they want the fence to pick up a masonry or composite look already on the property, or they’re pairing new fence panels with a Boral retaining wall or pier system.
Here’s the compatibility gotcha worth checking before you buy anything: Boral stone veneer profiles are nominal, not exact. A “6-inch” ledge course measures close to 6 inches but not quite, and panel heights, cap sizes, and pier caps have to be sized to the actual field measurement, not the catalog name. Measure the material in place with a tape and write the number down. Ordering off the spec sheet alone is how homeowners end up with caps that won’t seat.
To identify what you have, look for a stamp or label on the back of a veneer piece or the underside of a composite panel, usually a series or color code. Photograph it. On the OEM vs. aftermarket question: for Boral stone and brick profiles, an exact match matters because a near-match reads as a repair from the street. For fasteners, posts, and hardware, a quality aftermarket equivalent is fine and often better than what came in the original packaging. We don’t stock parts and we don’t carry them on a truck. We source to your match. Cambria, Silestone, and KraftMaid are part of the wider brand lineup we work with on other projects, but Boral is the one that matters here.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boral Fence Installation Is Failing
Fence problems in Antioch follow the climate. Clay soils that swell in winter and shrink hard by August, plus summer wind through the Delta corridor, will test any fence. Here’s what we see.
- Leaning or heaving posts. Usually shallow footings or a post set in soil that drains poorly. Antioch’s expansive clay does the rest, and a post that leans in year two rarely straightens on its own.
- Panels that stay bowed after rain. Water is getting behind and staying there. Either the material is composite that wasn’t given a drainage gap, or a masonry pier cap is holding moisture against the veneer.
- Color fading and chalky surface. UV exposure, plain and simple. Composite and painted finishes take heavy sun in Antioch, and a fence that was sold as low-maintenance still fades.
- Cracks at the base or along a cap seam. Movement, not material failure. Ground that shifts is opening the joint, and a hairline crack becomes a water channel fast.
- Loose or rusting fasteners. Usually the wrong coating for the application. Stainless or hot-dipped galvanized belongs anywhere moisture sits, and builders sometimes use neither.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Fence replacement in Antioch runs $3,500 – $9,000 installed for a typical residential run. The range is driven by linear footage, height, material (composite panels cost more than a masonry-look pier-and-panel design at low footage, and less at high footage), footing depth in clay, and how much tear-out you need.
Here’s how the number breaks down:
- Material, matched to your Boral profile: figure the high end if it’s a stone or brick match.
- Footings set below frost and sized for clay soil.
- Tear-out and haul-away of the old fence.
- Hardware, fasteners rated for moisture, and caps.
- Labor and cleanup.
Quotes are line-item. The number you see is the number you pay, with no change orders on the back end. Workmanship is covered by our 730-Day Done Right Promise, and if it’s not done right, we make it right. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available. Our technicians have up to 12 years of experience.
DIY or Call Us?
A homeowner can safely handle the diagnosis. Walk the fence line, check for lean with a level, photograph any label or stamp, and measure the actual dimensions of the material you need matched. That’s the part that saves you money, because you’ll know what you’re asking for before you call.
Where DIY goes wrong is the install itself. Footing depth in Antioch’s clay is the make-or-break detail, and a post set too shallow will heave within a season or two. Matching a Boral profile means knowing which pieces are nominal and coordinating caps and heights so they actually seat. And a masonry-look fence with piers carries real weight, so footing and panel connection aren’t a weekend project. Call (888) 419-3650 and we’ll walk you through what your fence needs before you spend a dollar on materials. Live person, 24/7.
FAQs
A quality composite or masonry-look fence in Antioch should last 15 – 20 years with proper footings, though color will fade in this sun regardless of what the material is sold as. Footing depth matters more than the material for lifespan, because clay movement kills most fences long before the panels wear out. Call (888) 419-3650 for an exact quote on your run, and estimates are free.
Often yes. A single leaning post, a few loose panels, or a resealed cap joint can usually be repaired, and that runs far less than a full replacement. If more than a short stretch is failing, repair costs climb toward replacement, and we’ll tell you which side of that line you’re on. Call (888) 419-3650 for an exact quote, and estimates are free.
A typical residential fence run takes two to four days, depending on footage, footing count, and how much tear-out is involved. Masonry-look designs with piers take longer than straight panel runs because each pier is its own footing. We’ll give you a timeline up front and stick to it. Call (888) 419-3650 to schedule your free estimate.
We source to your match using the photos and measurements you provide, then confirm the profile and color with you before anything is ordered. We don’t stock parts, so the part is ordered specifically to your job. Background-checked, uniformed technicians handle every install. Call (888) 419-3650 for an exact quote, and estimates are free.
If your Antioch fence is leaning, fading, or never matched the house the way you wanted, the fix starts with a real measurement and a line-item quote. Call (888) 419-3650 for your free estimate and design consult, and see what a Boral-matched fence actually costs for your property. Upfront pricing, no surprises, backed in writing with the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.