Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Kitchen Remodeling: The Antioch Owner’s Guide
Kitchen remodeling built with CGI cabinets and components in Antioch typically runs $14,000 to $45,000 installed, depending on layout, cabinet count, and countertop choice. We source CGI-compatible cabinet lines, install them, and stand behind the work with our 730-Day Done Right Promise. Most kitchen projects here aren’t a single-day job, and a scheduler will walk you through a realistic timeline when you call for your free estimate.
Owners usually figure out something is wrong the same way: a door that no longer lines up with the frame, a drawer that drags against the box, or a hinge that has quietly lost its spring tension over a hot Contra Costa summer. Sometimes it’s a finish that has started to peel near the cooktop. The point is you’re not guessing. You’re pricing. Call (888) 419-3650 and we’ll get you a written, line-item estimate.
Which CGI Models This Applies To
CGI’s residential cabinet lines span framed and frameless construction, and that distinction is the first thing we check on any Antioch kitchen. Framed boxes use a face frame and hinge into the stile; frameless units mount hinges directly into the side panel. Ordering the wrong hardware or a replacement door built for the wrong construction is the single most common mistake we see from a homeowner who tried to source it alone.
To identify your exact CGI model, look for the manufacturer label inside the door or on the back of the drawer box, then measure the opening, the overlay, and the hinge bore diameter. Those three numbers matter more than the model name. If the label is missing, a photo of the hinge and a tape measurement is enough for us to match it.
On the OEM-versus-aftermarket decision: for a door or drawer face where the finish must match the rest of the run, stick close to the original line. For internal hardware, a quality aftermarket soft-close hinge or slide often outperforms the OEM part at a lower cost. We’re an independent installer and not affiliated with CGI, so we’ll tell you honestly which route saves you money on your specific cabinets. Groundwork Construction Co. of Antioch also installs KraftMaid, Cambria, and Silestone alongside CGI work, so nothing about the rest of your kitchen has to be matched to a stranger.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Kitchen Remodeling Is Failing
- Sagging cabinet doors. A hinge that has lost its adjustment or a stile that has swelled from humidity. In Antioch’s dry-summer, wet-winter pattern, wood moves more than homeowners expect, and a door that only sags in spring is usually a moisture issue, not a broken hinge.
- Drawers that stick or come off track. Usually a worn slide or a box that has racked out of square. If the drawer only drags at the back, the rail is the suspect; if it drags along one full side, the box itself is the problem.
- Peeling or chipping finish near the range. Heat and steam degrade lower-grade finishes faster than the manufacturer’s spec sheet suggests. A localized repair is possible, but a full door replacement is the honest fix when the peeling has spread past a hand-sized area.
- Water staining under the sink. A leak you didn’t catch has soaked the cabinet floor and, in bad cases, the subfloor. This one isn’t cosmetic. The cabinet base often has to be cut out and replaced before new parts go in.
- Soft-close hardware that slams. The damping mechanism is the first thing to wear on any soft-close hinge or slide, usually after a few years of daily use. It’s a cheap part to swap, and it’s worth fixing early before the slamming shock damages the door or box.
Replacement Cost & What’s Included
Here’s what CGI kitchen work runs in Antioch, installed:
| Item | Installed Range |
|---|---|
| Full kitchen remodel (CGI cabinets) | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the number is cabinet count, whether the layout changes, countertop material, and whether any plumbing or electrical has to move. Our pricing is upfront: the number you see is the number you pay, no change orders slipping in mid-job. Every job is backed by the 730-Day Done Right Promise, so if something isn’t right, we make it right.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There’s a safe middle ground. You can check hinges, measure openings, and clean out a stuck drawer track without risk. What you shouldn’t do yourself is move a gas line to reposition a range, pull a permit-level electrical change, or tear out a cabinet run that hides water damage you can’t see yet. Those are where weekend projects turn into a wall opened up and a crew called in anyway.
Live person answers the phone 24/7 at (888) 419-3650. Every technician who shows up is background-checked and in uniform, and the estimate is free. There’s also $1,000 off projects over $10,000 and 0% financing for 18 months if the scope ends up larger than a single part.
FAQs
A well-built CGI cabinet line installed correctly typically holds up 15 to 25 years in this climate, with hardware like hinges and slides needing replacement sooner, often in the 5 to 10 year range. Antioch’s dry summers and wet winters stress wood cabinets more than a coastal climate would. For an exact lifespan read on your cabinets, call (888) 419-3650 and estimates are free.
Often yes. A single hinge, slide, or drawer face is a straightforward swap that costs far less than a full cabinet replacement. The repair stops making sense when the box itself has swelled, cracked, or soaked through, because new hardware on a bad box just fails again. Call (888) 419-3650 and we’ll tell you which one you’re looking at.
A single part swap, like a hinge or drawer face, is a same-visit fix. A full cabinet installation is a multi-day project, and a full kitchen remodel varies with scope, so we’ll give you a real timeline up front rather than a guess. Call (888) 419-3650 for a free estimate and a written schedule.
We source through CGI’s authorized lines and verified aftermarket equivalents, matched by the hinge bore, overlay, and box construction rather than the model name alone. We don’t carry parts on a truck or stock them locally; each part is ordered to match your cabinets, then installed on the scheduled visit. Call (888) 419-3650 to get your part matched.
Schedule Your Free Estimate in Antioch
If your CGI kitchen parts are failing or you’re ready to remodel, call (888) 419-3650 for a free project estimate and design consult. We’ll walk the kitchen, tell you exactly what needs replacing, and put an upfront price in writing. From foundation to finish line, Groundwork Construction Co. of Antioch handles the job with brand partners like KraftMaid, Cambria, and Silestone available when you want to expand the scope. Call today and talk to a live person, any hour.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.