Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Driveway & Pavers: The Antioch Owner’s Guide
We install and repair Oldcastle-compatible paver driveways and hardscape throughout Antioch, and most full paver driveway installations here land between $7,000 and $18,000 depending on square footage, base prep and whether we’re working over an existing slab. We’re an independent contractor and not affiliated with Oldcastle, but our technicians have up to 12 years of experience matching Oldcastle paver profiles and setting beds to the specific units already on your property. Small repairs and reset work often wrap in a single visit; full replacements get scheduled as a planned project.
Most Antioch owners find out something’s wrong the same way: a paver lifts after a heavy rain, a rut forms where the car parks, or a joint of polymeric sand washes out toward the street and leaves the blocks rocking underfoot. By the time it’s visible, the base or the bedding layer has usually been the real problem for a season or two.
Key Takeaways
- Antioch paver driveways typically run $7,000 – $18,000 installed; repairs and resets are far less.
- Most failures here trace to base prep and drainage, not the paver itself.
- We match Oldcastle unit profiles and colors by sample, not by photo.
- Workmanship is covered by our 730-Day Done Right Promise.
Which Oldcastle Models This Applies To
Oldcastle’s paver line covers a wide spread of profiles – interlocking rectangular systems, tumbled or rustic finishes, large-format slabs, and permeable units designed to pass water through the joints. The exact series names and dimensions shift over the years, and Oldcastle has retired and renamed collections more than once. That matters because a unit that looks identical in a driveway photo can differ by a quarter inch in height or a few degrees in chamfer, and a quarter inch is enough to leave a rocking edge or a visible seam where new meets old.
To identify what you actually have, pull one loose or damaged unit and measure it: length, width, thickness, and the spacing of any spacer lugs on the sides. Thickness is the number that matters most for matching. Standard residential pavers commonly run in the 2 3/8 to 2 3/4 inch range, and mixing a thicker unit into a thinner field creates a trip edge and a joint that won’t lock. Check the underside for a stamp or mold mark, and check the sides for lugs versus a flat, chamfered edge – that tells you whether the system was designed to interlock or butt together.
On the OEM-versus-aftermarket question: for pavers there isn’t really a true “OEM part” the way there is for a machine. The closest equivalent is a current-production unit from the same collection. When a collection is discontinued, a quality aftermarket paver of matching thickness, color family and texture is a legitimate option, and often the only one. What we don’t do is drop a mismatched unit into a visible field and call it close enough. We pull a sample, compare it in daylight against your existing pavers, and tell you honestly whether it’ll read as a match or stand out.
We also work with Belgard and other hardscape lines alongside Oldcastle, so if your existing driveway is a mix or you’re expanding into a new area, we can talk through what blends cleanly and what doesn’t.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Oldcastle Driveway & Pavers Is Failing
- Pavers rocking or shifting underfoot. This is the classic base failure – the aggregate base underneath has settled, lost compaction, or was never deep enough for Antioch’s clay-heavy soils. If a unit moves when you step on it, the bedding sand beneath it has already migrated.
- Rutting or depressions where cars park. Concentrated load over a soft or under-compacted base shows up as tire-track depressions, usually within the first few years if the subgrade wasn’t prepped. Once it’s rutted, top-dressing sand won’t fix it.
- Joint sand washing out after rain. Polymeric sand eroding toward the street on every storm points at a drainage problem – either the driveway isn’t sloped away from the structure or there’s no edge restraint holding the field together. In Antioch’s winter rain cycles, this is one of the most common calls we get.
- Efflorescence – the white, chalky haze. It’s mineral salts drawn to the surface as moisture moves through the paver, and it’s more common on newer installations and in damp, shaded areas. It can be cleaned, but recurring bloom often signals water sitting under the surface.
- Chipped edges, spalling, or loose field units near the apron. Freeze-thaw isn’t the driver here so much as heat cycling and vehicle traffic over a compromised base. Edge units take the worst of it, and once the perimeter restraint fails, the field starts to spread.
Replacement Cost & What’s Included
In Antioch, a full paver driveway installation runs $7,000 – $18,000, while a concrete driveway comes in at $4,500 – $12,000 and asphalt paving at $3,500 – $9,000. A driveway replacement – tear-out, haul-off and rebuild – lands around $5,000 – $14,000. Sealing runs $250 – $700. Paver patio work, if you’re extending, is $3,500 – $11,000.
What drives the range: total square footage, whether we’re tearing out existing concrete or pavers, how deep the base has to go to beat Antioch’s expansive soils, edge restraint and drainage corrections, and whether you’re matching an existing field or starting fresh. Every quote is an upfront number with the breakdown in writing, so the number you see is the number you pay. Workmanship is backed by our 730-Day Done Right Promise, and we offer 0% financing for 18 months, plus $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There’s real value in what an owner can safely do here. You can pressure-wash a dirty driveway, sweep in fresh joint sand on a stable field, spot-clean efflorescence with the right product, and inspect your edge restraint for gaps. Those are genuine maintenance tasks.
Where DIY goes wrong is anything that touches the base. Replacing a single paver looks simple until you pull it and find the bedding layer is a half-inch thin, or the unit you ordered doesn’t match thickness and now you’ve got a trip hazard. Base repair, recompaction and re-sloping are the parts that fail twice when done by hand – and on a driveway, a poor base is a re-do, not a patch. If your pavers are rocking, rutting or washing out, call us at (888) 419-3650 for a free estimate. We’ll tell you straight whether it’s a repair or a rebuild, with no-hassle upfront pricing and a live person on the line 24/7.
FAQs
A properly installed paver driveway can last decades. The pavers themselves are tough, but the base is what determines lifespan – in Antioch’s clay soils, an under-prepped base may start shifting within a few seasons. We document base depth and compaction on every job so the work is built to last, backed in writing by our 730-Day Done Right Promise.
Often yes. Isolated rocking units, a washed-out joint run, or one failed edge section can usually be reset with fresh base and sand. If the failure is widespread rutting or the base has settled across the field, a partial or full rebuild is the honest answer. Call (888) 419-3650 and we’ll assess it on site, free.
Most small repairs and resets are completed in a single visit. A larger section rebuild or full replacement is a planned project, scheduled to fit the work and the weather. We’ll give you a clear timeline in the written estimate so you know what to expect.
We pull a sample of your existing unit, measure thickness and dimensions, and match against current Oldcastle and Belgard production. If the collection is discontinued, we compare aftermarket options in daylight before committing. We don’t claim to stock pavers or carry them on a truck – we source what the job actually needs and tell you if an exact match isn’t available. We also handle KraftMaid, Cambria and Silestone work if you’re planning other improvements alongside the driveway.
Get Your Free Driveway Estimate in Antioch
If your Oldcastle pavers are rocking, washing out or past their prime, we’ll give you a straight assessment and an upfront number. Call Groundwork Construction Co. of Antioch at (888) 419-3650 for a free project estimate and design consult. Live person, 24/7. Background-checked technicians, uniformed on every job. From foundation to finish line, built to last and backed in writing.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.