Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Kohler Fence Installation: The Antioch Owner’s Guide
If you have a Kohler-labeled fence installation part that’s failing, we replace it at your Antioch property for $3,500 to $9,000 installed, with most hardware and swing-gate jobs landing in the $3,500 to $5,500 band. The part rarely announces itself. Homeowners in Antioch usually discover it the same way: a gate that drops and drags on the concrete in summer, a hinge or latch they ordered from a spec sheet that came up short by an eighth of an inch, or a section that leans a little more after every windy February. What started as a hardware swap often turns into a full panel-and-post install once the old footings are exposed. We price it honestly before anyone digs.
Which Kohler Models This Applies To
Kohler is best known for plumbing, so the fence hardware, hinges, latches and hardware kits that carry the Kohler name are usually sourced through a fence or gate manufacturer’s program rather than Kohler’s own plant. That matters because compatibility lives on the hardware sku, not the Kohler logo. Before we quote, we find three things on the existing part: the model or part number stamped on the hinge leaf or latch body, the post-to-gate measurement taken at the stile centers (not the edge), and the spacing between hinge bolt holes. Hinge and post cap sizes commonly run in a 3-1/2 to 4 inch band, and a quarter-inch isn’t close enough. When a genuine Kohler part is discontinued or on a long lead time, we’ll recommend a quality aftermarket equivalent where the spec matches, and we’ll tell you plainly what you give up. We’re an independent installer, not affiliated with Kohler.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Kohler Fence Installation Is Failing
- Gate sags and drags the ground. Worn hinge bearings and a post that’s settled in Antioch’s expansive clay are the usual suspects. The hinge is the cheap fix; the footing is the real one.
- Latch won’t catch or pops open. A stretched latch spring or a strike plate that’s drifted out of alignment with the gate. If the gate has shifted, the latch is a symptom, not the disease.
- Posts lean after rain. Poor drainage around the footing, or a footing set too shallow for our soil. This is the most common failure we see on older Antioch fences.
- Rust at hardware contact points. Our wet winters and drier summers accelerate corrosion at bolt threads and weld seams, especially on cheaper plated hardware. Stainless or hot-dipped is worth the upgrade.
- Sections wobble in the wind. Loose rail fasteners or a toppled post cap letting water in. Catch it early and it’s a repair; wait a season and it’s a replacement.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Antioch, expect $3,500 to $9,000 for a Kohler-compatible fence installation, hardware and labor included. Vinyl fence installation runs $3,500 to $9,000; aluminum fence installation runs $4,000 to $10,000. The range moves with linear footage, post count, gate complexity, footing depth and whether we’re replacing hardware on existing posts or setting new ones. Your quote is a written line-item breakdown: materials, hardware, digging and concrete, gate build, and haul-away. The number you see is the number you pay, and the work is covered by our 730-Day Done Right Promise. We also offer 0% financing for 18 months and $1,000 off projects over $10,000.
DIY or Call Us?
You can safely check the obvious: wiggle the gate, look for rust at hinge pins, measure the sag, and confirm the post is sound by pushing on it. Where DIY goes wrong is the digging. A gate post set into Antioch’s clay without a proper concrete footing and drainage will lean again within a season or two, and a hinge swap on a settled post just hides the problem. We’re honest about the split: if it’s a latch spring, that’s a five-minute fix worth trying yourself. If it’s a post, footing or anything load-bearing, call us at (888) 419-3650 and we’ll get a free estimate on the calendar. Background-checked, uniformed technicians on every job.
FAQs
A properly installed fence with quality hardware should give you 15 to 20 years before hardware needs real attention, though in Antioch’s wet-winter, dry-summer swing, expect to inspect hinges and post footings every 3 to 4 years. Call (888) 419-3650 for a free estimate on replacement.
Often yes. A single hinge, latch or bent rail can be swapped without touching the rest of the fence. We’ll tell you honestly whether repair or replacement is the better spend, and we won’t sell you a new fence if a repair will do.
Hardware-only replacement is usually a single visit of a couple of hours. A full post-and-panel install typically runs 1 to 3 days depending on linear footage and gate count, and we give you the schedule in writing up front.
We match the part number, hinge spacing and post measurement to a verified supplier, and we don’t install anything we can’t stand behind. When the genuine part is discontinued, we source a spec-matched quality equivalent and explain the difference before you decide.
Ready to price it? Call Groundwork Construction Co. of Antioch at (888) 419-3650 for a free estimate. We also work with KraftMaid, Cambria and Silestone on the interior side if your project expands.
Written by the team at Groundwork Construction Co. of Antioch, serving Antioch and nearby areas.