A Groundwork company - serving Antioch, CA

Schluter Home Additions & ADU in Antioch, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Schluter Home Additions & ADU: The Antioch Owner’s Guide

We install Schluter-compatible home additions and ADU systems across Antioch, and a full addition project typically runs $45,000 – $130,000 depending on square footage, foundation work, and finish level. The Schluter side of the work is the waterproofing and uncoupling layer under your tile: shower membranes, shower trays, curb profiles, and the underlayment that carries a new bathroom floor in a converted garage or attached suite. Owners usually figure out something is wrong the same way: a soft spot in a new shower floor, grout cracking in a straight line across a bathroom tile field, or a faint musty smell in an ADU bathroom that never quite dries out. That’s not a tile problem. It’s the membrane underneath.

Call (888) 419-3650

Key Takeaways

  • Schluter failures in Antioch additions usually trace to one of four things: wrong membrane for the substrate, a missed seam, a tray that wasn’t bedded correctly, or floor movement in a converted space.
  • Typical installed repair or replacement runs $1,800 – $6,500 depending on whether tile has to come up.
  • The part itself is cheap. The labor to get to it is the cost.
  • We’re an independent contractor, not affiliated with Schluter. We work with their systems every week.

Which Schluter Models This Applies To

Schluter isn’t a single product. For additions and ADUs, the parts that matter are the Kerdi waterproofing family (Kerdi-Band, Kerdi-Fix, Kerdi membrane rolls), the Kerdi-Shower tray and curb lines, Ditra and Ditra-Heat uncoupling membranes, and the profiles: Schluter-RENO, Schluter-QUADEC, and Schluter-JOLLY edge trims. Each has its own size table. Kerdi-Shower trays come in a fixed set of dimensions (roughly 32×60 up to 48×72 in common configurations), and the drain position is off-center by design, so measuring your rough opening wrong by even an inch means the tray won’t seat without cutting, and cutting a pre-sloped tray breaks the slope. Ditra comes in 3/16″ and 1/4″ thicknesses; using the wrong one over a plywood subfloor in a converted garage changes your finished floor height enough to throw off door clearances.

Identifying the right part is a matter of the printed roll label and the tray’s molded stamp on the underside. If the label is gone, measure the roll width and look at the fleece texture, since Kerdi and Ditra read completely differently to the touch. On OEM versus aftermarket: Schluter’s own materials are the safe call for waterproofing because the warranty chain depends on using their full system. For profiles and trims, a quality equivalent in the same dimension works fine. What we don’t do is claim to stock any of it. We source to spec per job.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Schluter Home Additions & ADU Is Failing

  • Grout cracking in a straight line. Cracks that follow a seam or tile joint, rather than spider-webbing across a single tile, point to membrane movement or a failed band overlap. The uncoupling layer is letting the floor flex under the tile.
  • A soft or hollow-sounding shower floor. Tap the shower floor with a screwdriver handle. A dull thud instead of a sharp tap means the tray or mortar bed has debonded, and water is sitting in the void.
  • Musty smell that returns after cleaning. In an Antioch ADU, this is often a shower that never fully dries because the waterproofing is holding moisture against the substrate instead of shedding it. Our delta breeze hides it for months, then summer heat brings the smell back.
  • Lippage at tile edges near a drain or curb. Tile sitting proud of its neighbor right at the drain flange usually means the tray wasn’t bedded level or the flange seal failed.
  • Efflorescence or white crust on grout lines. Minerals wicking through a compromised membrane. It looks cosmetic. It’s the early warning before a leak shows up on the ceiling below.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Antioch additions and ADUs, a targeted Schluter repair runs $1,800 – $3,200 when the tile can be saved or the affected area is small. A full shower membrane and tray rebuild with new tile runs $3,500 – $6,500. A floor uncoupling replacement across a converted garage or ADU bath runs $2,400 – $5,800 depending on square footage and whether the tile is being reused. The range is driven by three things: how much finished surface has to come up, whether the substrate underneath is sound, and whether the existing Schluter system can be extended or has to come out entirely.

What’s in the quote: removal, substrate prep, the Schluter system components, tile labor, and cleanup. We give you a written line-item quote before anything starts. Upfront pricing, no surprises: the number you see is the number you pay. The installed work is covered by our 730-Day Done Right Promise, so if a seam fails or a tray lifts, we come back and make it right.

DIY or Call Us?

Here’s the honest split. You can safely check for a failed membrane yourself: tap the floor, look for straight-line grout cracks, check for white crust at grout lines, and sniff the ADU bathroom after a week away. That’s diagnosis, and it costs nothing.

What you shouldn’t do is re-seal, re-grout over a crack, or try to patch a Kerdi seam with caulk and call it done. Grouting over a moving substrate hides the symptom for a season and lets water migrate further into the wall cavity. Those band overlaps have a specific 2-inch minimum, and a homemade patch won’t hold it. Water damage in a new addition is expensive to undo: framing, insulation, drywall, and the tile all come out. Call (888) 419-3650 and we’ll look at it before it spreads.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 419-3650
Local Service Coverage

Request a Free Estimate in Antioch

Tell us what you need - Groundwork Construction Co. of Antioch responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch