A Groundwork company - serving Antioch, CA

Tremron Driveway & Pavers in Antioch, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tremron Driveway & Pavers: The Antioch Owner’s Guide

Tremron paver driveways and patios across Antioch typically run $7,000 – $18,000 installed for a driveway and $3,500 – $11,000 for a patio, and we can usually walk a failing paver surface the same week you call. The material itself rarely fails first. What fails is the base under it, the joint sand between the units, or the edge restraint holding the field in place. That’s how most Antioch owners find us: a low spot holding water after a winter storm, sand washing out of the joints along the slope, or a spread of pavers creeping at the driveway entrance where the car turns in.

Call (888) 419-3650

We install Tremron pavers and we repair failing Tremron installations. We’re an independent contractor, not affiliated with Tremron.

Key Takeaways

  • Paver failure in Antioch is almost always a base, drainage, or edge restraint problem, not a bad paver.
  • Installed pricing depends on square footage, base depth, and access, not just the paver cost per unit.
  • Joint sand and edge restraints are the two cheapest things to fix early and the most expensive to ignore.
  • Every job is covered by our 730-Day Done Right Promise.

Which Tremron Models This Applies To

Tremron manufactures a broad paver line, and the units sold in Antioch are almost always from their pavers family – structured lines like Olde Towne, Capri, and similar series, plus their Mega Olde Towne and Mega Bergerac block for driveways that take vehicle load. The exact series and color names matter more than owners expect, because Tremron’s component pavers, edge units, and specialty pieces are sized to specific series. If you’re matching new pavers to an existing patio, we measure the actual unit face and thickness with a tape, not just the color swatch. Face dimensions and nominal thickness need to line up, and older installations sometimes show units that were laid to a slightly different specification than what’s currently in production.

How to identify what you have: lift one loose paver from an edge, measure it in both directions and check thickness, then match the layout pattern – stacked, running bond, herringbone – to Tremron’s published pattern sheets. The OEM-versus-aftermarket call is straightforward. For straight-run field pavers, a quality Tremron-series match is what you want, and we source through the manufacturer. For edge restraints, joint sand, and polymeric products, quality alternatives exist and we’ll tell you when one makes sense. Our broader material network includes KraftMaid, Cambria, and Silestone on the interior side, but Tremron is the paver spec we recommend for Antioch hardscape.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tremron Driveway & Pavers Is Failing

  • Joint sand washing out after rain. The sand between pavers is the first thing to go in Antioch’s winter storms. As it drops below the surface, joints open, water gets under the field, and the base starts settling.
  • Pavers rocking or shifting underfoot. A rocker means the bedding layer or base under that unit has failed. One paver usually signals a pocket of base failure nearby, not an isolated loose stone.
  • Edge spread at the driveway apron. This is the most common Antioch failure we see, especially where the driveway meets the street. The edge restraint has failed, the field creeps downhill, and joints open up. On sloped entries, the load of backing out of the drive does the rest.
  • Low spots that hold water. Ponding after rain is a drainage and grading signal. Water pooling against the edge of the drive or patio works its way into the base, and the swale that should carry water away has flattened or filled.
  • Efflorescence and discoloration. White mineral deposits on the surface are common in Tremron pavers, more so on new installations and after wet seasons. They usually clear on their own, but if they keep returning over months, that points to moisture moving through the base.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Antioch pricing for Tremron paver work breaks down like this:

Scope Installed Range
Paver driveway installation $7,000 – $18,000
Paver patio installation $3,500 – $11,000
Driveway replacement (remove old, reinstall) $5,000 – $14,000
Joint sand and edge restraint repair Quoted per job after inspection

What moves the number: total square footage, how deep the base has to be built (driveways need a deeper aggregate base than a patio), how much old material comes out, drainage work to redirect runoff, and access for a skid steer. Smaller jobs with tight side-yard access cost more per square foot. We quote parts and labor as a line-item breakdown: units, base, bedding, edge restraint, joint sand, labor. The number you see is the number you pay, no change orders for hidden conditions we should have caught on the walk. All work carries our 730-Day Done Right Promise.

DIY or Call Us?

Some of this you can check safely. Walk the surface in a downpour and photograph where water pools. Inspect the perimeter for a failing edge and pull a loose paver to measure it. Those checks tell you what you’re dealing with and cost nothing.

Where the DIY path goes wrong: rebuilding a base. Paver failure is rarely solved by resetting stones in sand. Fixing it right means excavating to the correct depth, compacting in lifts, re-establishing a slope that drains, and locking the perimeter in with new edge restraint. Skip any of that and the same spreading shows up again after the next wet winter. That’s also the expensive part, because the paver is the cheap piece of the job and the base is where the labor goes. Call our team at (888) 419-3650 and we’ll look at it and quote the repair or the full rebuild, with a free estimate.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 419-3650
Local Service Coverage

Request a Free Estimate in Antioch

Tell us what you need - Groundwork Construction Co. of Antioch responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch