Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Alamo, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Alamo, CA typically costs $3,500 – $10,000 and takes 5 to 10 working days once demolition starts. We remove the old tub, rework the drain and waterproofing, install a new shower pan, walls and valve, and set tile or a solid-surface surround. Most Alamo conversions stay in the $6,000 – $8,500 band. Every project begins with a free on-site estimate, and you can reach us at (888) 419-3650 to schedule one.

How our crew runs a tub-to-shower conversion, stage by stage
The work follows a fixed sequence. What changes from house to house is how much plumbing, framing or floor repair we uncover along the way. Here’s the order, with the durations we see on Alamo jobs.
Day 1: Assessment and demolition
We pull the tub, surround, valve trim and any glass doors, and open the wall behind the shower valve. On older Alamo homes, this is where we find out whether the drain is cast iron, copper or PVC and whether the subfloor is sound. A full demo of a standard alcove runs 4 to 6 hours. You decide the shower footprint and drain location before we frame anything.
Day 2: Rough plumbing and framing
We relocate the drain to the center of the new pan, set the valve body at the correct height, and add blocking for grab bars and a future bench. If you’re switching to a linear drain or a curbless entry, this is the point of no return for the floor structure. Rough-in inspection usually happens the same day or next morning, depending on the county inspector’s schedule.
Day 3: Waterproofing
We build the sloped pan, then apply a bonded waterproofing membrane over the walls and floor. Schluter Kerdi is our default system because it carries a manufacturer warranty and handles the curb and corners in one continuous layer. Waterproofing cures overnight. No tile goes up before it’s done.
Days 4 – 7: Tile or panel installation and fixtures
Wall tile, floor tile and any niche work go in here. A large-format porcelain install runs three to four days; a prefabricated solid-surface surround can be done in a single day. We set the valve trim, showerhead and drain grate last. You’ll pick trim finish and head type before this stage starts, not during it.
Days 8 – 10: Grout, sealant, glass and final inspection
Grout and silicone cure, glass gets templated and set, and the final inspection closes the permit. We walk the job with you, test the drain slope, and hand over care instructions. Most Alamo conversions wrap in 10 working days from the first hammer swing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Three decisions drive most of the cost and the feel of the finished shower. Make them before demolition, not after.
- Wall surface: Large-format porcelain tile (most durable, $3,000 – $5,500 installed) versus a prefabricated acrylic or solid-surface surround (faster, fewer grout lines, $1,200 – $2,500). Tile suits Alamo’s custom home interiors; a surround suits a rental or a fast flip.
- Shower pan: Preformed acrylic pan, a Schluter-tiled mud pan, or a curbless wet-room floor. Curbless entry requires structural review and costs $800 – $2,000 more, but it’s the right call for aging-in-place.
- Fixtures: A Toto or Grohe thermostatic valve with matching trim runs $400 – $900; a basic pressure-balance valve runs $150 – $300. Sterling makes solid mid-tier pans and surrounds if you want a clean look without custom tile.
- Glass: Frameless 3/8″ glass ($900 – $1,800) versus a framed slider or a simple curtain rod. Frameless looks right in a custom Alamo bathroom; the slider is easier on the budget.
- Drain: Centered point drain versus linear. Linear needs a different slope and costs $300 – $600 more.
What Tub-to-Shower Conversion costs in Alamo, CA
Plan on $3,500 – $10,000 for the conversion itself. Where your job lands depends on five variables:

- Shower size: A standard 60″ alcove sits at the low end. A 48″x60″ walk-in or a converted tub alcove with a bench pushes toward $8,000+.
- Existing condition: Rotted subfloor, cast-iron drain replacement or water damage behind the tub adds $500 – $2,000.
- Moving plumbing or electrical: Relocating the drain, adding a niche with wiring, or moving the valve to the opposite wall adds $600 – $2,500.
- Material grade: Acrylic surround and stock tile versus imported porcelain, custom niches and frameless glass – a $3,000 gap on the same footprint.
- Permit scope: A straightforward drain/valve permit is modest; if the job becomes a full wet-wall rebuild with structural changes, the county review grows and so does the cost.
A written estimate lists demo, rough plumbing, waterproofing, tile or surround, fixtures, glass and permit fees line by line. It typically excludes structural repair found after demo, glass upgrade beyond the quoted spec, and any HOA or county fees tied to hillside access.
See the difference
Before
After
Before
After
Before
AfterWhat Alamo homes specifically do to this job
Alamo (ZIP 94507) is unincorporated Contra Costa County, so every tub-to-shower conversion here runs through the county building department and CCC Fire, not a city hall. On the estate lots off Stone Valley Road and the long private driveways tucked off the valley floor, that means scheduling an inspector who comes from the county, and on hillside properties it can also trigger a geotechnical look at drainage if the shower sits near an exterior wall on a slope. The housing stock matters too: most of these homes were built between the 1950s and the 2000s as custom ranch and Mediterranean estates on half-acre-plus parcels. That era gives us original cast-iron or copper drains, layered past remodels, and sometimes a second-floor shower over a framed floor that needs reinforcement before we set a curbless pan. Where a bathroom conversion is part of a larger Bathroom Remodeling in Alamo scope, we sequence it into the wider project. And because the San Ramon Valley’s dry summers and Diablo-wind exposure push homeowners toward defensible-space and fire-hardening work, this conversion often gets paired with exterior upgrades – Metal Roofing in Alamo and Tile Roofing in Alamo are a common combination on the same property.
Serving Alamo, CA – Our Local Coverage Area
We serve Alamo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Tub-to-Shower Conversion in Alamo
Most conversions run 5 to 10 working days from demo to final inspection. The variable is what’s behind the tub – rotted subfloor or an old cast-iron drain can add a day or two. Call (888) 419-3650 for a firm date range on your specific bathroom.
Yes. Moving the drain or valve requires a permit through Contra Costa County, and we pull it and pass the inspection for you. We don’t leave the paperwork to you.
If the drain stays centered in the old tub footprint and the valve stays on the same wall, yes – most jobs need only a short drain relocation. That keeps cost near the low end of the range.
Between $3,500 and $10,000, with most jobs landing in the $6,000 – $8,500 band. Material grade and whether you go curbless are the biggest movers. Call (888) 419-3650 for an exact quote – estimates are free.
Every conversion falls under our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers labor and installation for two full years. Call (888) 419-3650 to book your free on-site estimate and see the written line-item quote.
Get a free tub-to-shower conversion estimate in Alamo
Call (888) 419-3650 to schedule a free on-site estimate for your Alamo bathroom. We come out, measure the alcove, look behind the wall where we can, and hand you a written line-item quote before you commit to anything. Our Bathroom Remodeling team covers the wider scope if you want it, and we serve the whole Alamo valley.
Written by the team at Groundwork Construction Co.