Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Walnut Creek, CA: What It Takes and What It Costs
A wood fence on a typical Walnut Creek lot runs $3,500 to $9,000, and most jobs are built in two to four days once materials land on site. You’re choosing a species and a style, setting post depth and spacing for soil that shifts between wet winters and hard dry summers, and deciding how the fence meets grade on a sloped yard. Call (888) 419-3650 and we’ll walk the property line with you.
How a Wood Fence Gets Built Here, Stage by Stage
Fence work looks simple from the street. The reason one fence stands straight for twenty years and the one next door leans after three comes down to what happens before a single board goes up. Here’s the real sequence.

Stage 1: Site walk and line verification (day 1, about an hour)
We walk the property line with you, confirm where the fence actually goes, and flag anything in the way: irrigation lines, a gas stub to the grill, low-voltage landscape lighting, tree roots from a mature oak or redwood. This is the point where you decide fence height and whether you’re building on the line or just inside it. On sloped lots in the hills, we talk through stepped panels versus racked panels before anything gets ordered.
Stage 2: Utility locate and demo (day 1, two to four hours)
Before digging, the underground service alert gets called and marked. Old fence comes out, posts and concrete footings included. If the previous fence was set in shallow concrete, we break it out and haul it. You decide at this stage whether to keep any existing gate hardware or start fresh.
Stage 3: Layout and post setting (day 1 into day 2)
We string the line, mark post spacing (typically 8 feet on center, tighter on taller or wind-exposed runs), and dig. Posts go in concrete and cure before any framing load goes on them. This is the single biggest schedule variable: post concrete needs time to set, and we don’t rush it.
Stage 4: Framing and boards (day 2 into day 3)
Rails, then pickets or board-on-board. You’ve already locked in the style at this point. This is also when we hang the gate and set the latch so it swings clean and closes without dragging. On a long run, this stage is where the day gets long.
Stage 5: Finish, cleanup, walkthrough (day 3 or 4)
Final inspection of post alignment, board height, gate swing, and any stain or seal coat you’ve chosen. We clean the site and walk it with you. If something isn’t right, it gets fixed before we leave, not on a callback.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on a Wood Fence
Most of the decisions on a wood fence are made in the first conversation, because material lead time drives the whole schedule. Here’s what you’re picking between and what each one really costs you.
- Cedar versus pressure-treated pine. Cedar costs more per linear foot but resists rot and insects without chemical treatment, and it takes stain beautifully. Pressure-treated pine is the budget play and holds up fine, but it moves more as it dries and needs sealing sooner. For a front-facing fence on a high-end Walnut Creek property, cedar is usually the right call.
- Dog-ear versus flat-top versus French Gothic pickets. Style is purely visual, but the profile affects how the top of the fence weathers. Flat-top sheds water cleanly; dog-ear catches less wind. Neither changes the structural cost much.
- Board-on-board versus side-by-side. Board-on-board overlaps pickets for full privacy with no gaps, and it’s the standard for a backyard screen. Side-by-side is cheaper and lets wind through, which matters on an exposed ridge.
- Post depth and footing. In Walnut Creek’s clay-heavy soil, posts need to go below the frost-influenced zone and sit in properly sized concrete footings. Skipping depth here is the number one cause of a leaning fence two winters later.
- Stain and seal. A penetrating stain every three to five years keeps cedar looking new. Skip it and you’ll see gray weathering within two summers of the dry heat.
What a Wood Fence Costs in Walnut Creek, CA
Plan on $3,500 to $9,000 for a wood fence in Walnut Creek. That range covers a standard residential run with cedar or pressure-treated framing, posts set in concrete, and a gate. Five things push a job toward the top of that range:
- Linear footage and height. A 60-foot side-yard run and a 200-foot perimeter are different jobs. Six-foot privacy fencing costs more per foot than four-foot.
- Site access and slope. A hillside lot with no truck access means hand-carrying materials and more labor hours. Stepped panels on grade take longer than flat runs.
- Demo and haul-away. Removing an old fence with deep concrete footings adds cost that a clean lot doesn’t have.
- Material grade. Clear-grade cedar at the top end, treated pine at the bottom. The gap is real.
- Gates and hardware. A single pedestrian gate is straightforward. A wide double gate or one with a self-closing hinge adds cost.
Your written estimate should show linear footage, species, picket style, post spacing, gate count, and whether stain is included. It should also state what’s excluded: stump grinding, irrigation rerouting, and any repair to a retaining wall the fence sits on. You get the number up front, and the number you see is the number you pay. Pairing the fence with Paver Driveways in Walnut Creek is common when the front yard is getting reworked at the same time.
See the difference
Before
After
Before
After
Before
AfterWhat Walnut Creek Homes Specifically Do to This Job
Walnut Creek is a market of two halves, and a wood fence has to answer to both. Most of the housing stock here is 1950s to 1970s single-story ranches and split-levels, and those lots often have original fencing that’s forty years old and failing at the posts, not the boards. The other half is newer custom and infill construction driven by the Lamorinda and Diablo Valley demand, where a fence is expected to match the architecture and pass design review.

Permitting is the part that catches people. Fences under a certain height typically don’t need a permit, but a fence on a corner lot, in a front setback, or on a hillside parcel with a view corridor easement can trigger plan review. We check before we dig, not after.
The climate shapes the build too. Hot, dry summers mean we schedule exterior work to avoid peak afternoon heat, and the mild wet winters can delay a dig by a few days when the clay is saturated. In the hills, wildfire risk drives homeowners toward fire-resistant materials and defensible-space clearances, which we factor into the layout. And on the older ranches, we regularly find irrigation and old electrical runs right where the new posts need to go, so a utility locate isn’t optional. This is part of the wider scope covered on our Fence Installation in Walnut Creek page, and if the fence is part of a larger yard rebuild we handle that through our Fence Installation service.
Serving Walnut Creek, CA – Our Local Coverage Area
We serve Walnut Creek and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Wood Fence in Walnut Creek
Most residential wood fence jobs take two to four days once materials are on site. Weather, slope, and demo of an old fence are the main variables. Call (888) 419-3650 for a timeline on your specific lot.
Often not, but not always. Height, front setback, corner lots, and hillside parcels with view easements can all require review. We confirm the rules for your address before we order material.
In most cases yes. We call for a utility locate first and route posts around irrigation, gas stubs, and low-voltage lighting. If a line has to move, we tell you before we start, not mid-dig.
Typical residential jobs land between $3,500 and $9,000, depending on footage, height, species, slope, and gate count. Call (888) 419-3650 for an exact quote, free on site.
Every fence we build is covered by our 730-Day Done Right Promise. If something isn’t right, we make it right. That’s the whole point of putting it in writing.
Homeowners often pair a new fence with Concrete Driveways & Concrete Work in Walnut Creek when the front approach is part of the plan. We cover the full Walnut Creek area, including the 94596, 94597, 94598, and 94595 ZIP codes.
Get a Free Wood Fence Estimate in Walnut Creek
Call (888) 419-3650 and a live person answers, any hour. We’ll set a time to walk your property line, talk through species and style, and leave you with a written, line-item estimate for your wood fence in Walnut Creek. Background-checked, uniformed technicians handle the work. Free estimate and design consult, and 0% financing for 18 months on approved projects.
Written by the team at Groundwork Construction Co.