Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Patios, Walkways & Pool Decks in Livermore, CA: What to Expect
Patios, walkways & pool decks in Livermore usually run $3,500 to $11,000 for a paver patio, with most full projects landing between $6,000 and $14,000 once walkways and pool coping are included. A typical job takes four to nine working days from demo to final sweep. Call (888) 419-3650 for a free on-site estimate – we’ll walk the yard with you, measure, and put real numbers in writing.

How We Build a Patio, Walkway or Pool Deck in Livermore
Every project follows the same five stages. Here’s what actually happens, in order, with real time attached to each one.
1. Layout and utility check (day 1, 1-2 hours)
We mark the footprint with paint and string lines, confirm slope away from the house, and call 811 for utility locating before anything gets cut. If your pool equipment, irrigation lines or gas stub sit inside the footprint, this is where we find out. You decide final dimensions and where the walkway meets the lawn or fence line.
2. Demolition and haul-off (days 1-2)
Old concrete comes out with a breaker and gets hauled to a licensed facility. A 400 square foot slab typically takes a day to break and load out. You’ll see the subgrade for the first time here, and that’s where surprises live – soft fill, old tree roots, or a slab poured over brick rubble from an earlier era.
3. Base prep and compaction (days 2-4)
This is the stage that decides whether your patio still looks flat in 2035. We excavate 6-8 inches, lay woven geotextile fabric, then build up class II base in 2-inch lifts with a plate compactor between each one. On Livermore’s clay, that base layer matters more than the paver you pick. You don’t have decisions to make here – just watch the compaction passes.
4. Setting the pavers, steps and coping (days 4-7)
Bedding sand goes down, pavers get laid in your chosen pattern, and cuts happen at edges and around the pool. Steps, seat walls and pool coping get set in mortar. A 500 square foot patio with a walkway runs about three days. You’ll confirm pattern direction and border style on the morning we start laying.
5. Joint sand, sealer and final walk (day 7-9)
Polymeric joint sand gets swept in and watered to activate. We return after a full cure for sealer if you chose it, then walk the job with you line by line. Drainage test happens here – we pour water and confirm it runs away from the house, not toward it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Nearly every decision on this job comes down to four choices. Here’s the honest trade-off on each.
- Concrete pavers (Belgard, Tremron, Unilock) – $3,500-$11,000 for a typical patio. Interlocking units on a compacted base, replaceable one at a time if a section fails, and they handle Livermore’s clay movement far better than a poured slab because the joints flex instead of cracking. Best all-around pick for patios and pool decks.
- Poured concrete with a broom or exposed-aggregate finish – the lowest up-front number, and a genuinely good option for straight walkways. The catch is Livermore’s soil: expansive clay cracking slabs is the single most common failure we see on 94550 properties, so control joints and a reinforced base aren’t optional.
- Natural or manufactured stone veneer on walls and steps – adds $1,800-$4,500 depending on linear feet. Seats walls, step risers and fireplace surrounds. Heavier, slower, and worth it where the patio needs to hold grade.
- Sealer and polymeric joint sand – a few hundred dollars, extends the life of the joint sand, reduces weed growth and cuts fading. Skip the cheap acrylic sealers; they haze and peel in Livermore’s summer heat.
Pool decks have one extra choice: standard pavers versus a permeable system. Around a pool, we usually recommend a permeable joint detail so splash-out drains instead of puddling on the coping. Techo-Bloc’s permeable line works well here, and so do standard pavers set with open-graded joint material.
What Patios, Walkways & Pool Decks Costs in Livermore, CA
A paver patio in Livermore runs $3,500 to $11,000. Add walkways and pool coping and full projects commonly reach $6,000 to $14,000. Concrete walkways sit lower; extensive retaining and steps push higher.

Five things move the number:
- Square footage – the single biggest lever. Every 100 square feet adds roughly $700-$1,400 installed.
- Demo and haul-off – removing an existing slab adds $600-$1,800 depending on thickness and access for a dumpster.
- Grade and drainage – a yard that slopes toward the house means a retaining wall or regrade. Budget $2,000-$6,000 when drainage work is in scope.
- Material grade – a basic Tremron paver and a premium Techo-Bloc unit can differ by 40% on material alone.
- Extras – steps, seat walls, fire pits, lighting conduit, built-in grill pads. Each adds a line item, quoted separately.
Every written estimate we hand over is line-itemed: demo, base, material, labor, extras, tax. The number you see is the number you pay – no change orders unless you ask for a change. Not included on a standard quote: pool equipment repairs, irrigation reroutes, gas line relocations and any structural repair found under the old slab.
See the difference
Before
After
Before
After
Before
AfterWhat Livermore Homes Specifically Do to This Job
Livermore sits on the Greenville Fault, and that reality lands directly on outdoor construction. When we set a seat wall, a pergola post or a pool deck near the house, footing depth and anchoring have to meet seismic bracing standards that many older downtown homes and ranch-style builds were never built to. On pre-1960s properties in 94550, that often means we’re coordinating a paver project with a foundation or cripple-wall retrofit at the same time – and the patio has to be built after, not before, the retrofit is signed off. This is also a wildfire-interface town at the edge of the Diablo Range, so any wood structure attached to a patio (pergola, shade cover) needs fire-resistant detailing and non-combustible materials near the house. Clay-heavy soils and 100°F summers do the rest: slabs crack, paver edges heave, and drainage that looked fine in April shows its problems in January. We build every base and every joint with that cycle in mind.
If the yard work is part of a bigger scope, we often handle it alongside a full Driveway & Pavers in Livermore project so grading and drainage get planned together. Homeowners often pair pool deck work with ADU Site Prep & Utilities in Livermore when a detached unit is going in the back, since utility trenches cross the patio footprint, and with Full Kitchen Remodeling in Livermore when the backyard is getting finished at the same time. Our Driveway & Pavers service covers the full range, and we work throughout Livermore and the surrounding East Bay.
Serving Livermore, CA – Our Local Coverage Area
We serve Livermore and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Patios, Walkways & Pool Decks in Livermore
Most patios, walkways & pool decks in Livermore take four to nine working days from demo to final walk, with weather days added during the rainy season. A simple 300 square foot patio lands near four days; a full pool deck with coping and a walkway runs closer to two weeks. Call (888) 419-3650 and we’ll give you a day-by-day schedule with your estimate.
Flat patios and walkways at grade usually don’t require a permit, but structures attached to the house, retaining walls over a set height, and pool decks tied into pool equipment almost always do. We handle the permit application and inspection scheduling as part of the job, and we’ll tell you up front whether the city will want drawings. Call (888) 419-3650 to talk through your specific layout.
Yes – most projects are laid out around existing pool equipment, irrigation and gas stubs, and we call 811 before we cut so nothing surprises us. When a line genuinely sits in the way, we quote the relocation separately rather than absorbing it silently into the job. Call (888) 419-3650 and we’ll walk the yard to see what’s actually in the footprint.
A paver patio in Livermore typically costs $3,500 to $11,000, and full projects with walkways and pool coping reach $6,000 to $14,000. The spread comes down to square footage, base prep, drainage and material grade. Call (888) 419-3650 for a free line-item estimate on your actual yard.
Every patio, walkway and pool deck we build is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it covers the installation, not just the material. Call (888) 419-3650 with questions on coverage before you sign anything.
Get a Free Estimate on Patios, Walkways & Pool Decks in Livermore
We’ll come out, measure your yard, talk through material options and drainage, and leave you with a written line-item estimate – no pressure, no vague ballpark. Calls are answered by a live person, day or night, and technicians arrive background-checked and in uniform. If the project is over $10,000, we take $1,000 off, and 0% financing for 18 months is available. Call (888) 419-3650 to schedule your free estimate in Livermore.
Written by the team at Groundwork Construction Co.