Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Alamo, CA: What the Job Actually Takes
A paver driveway in Alamo typically runs $7,000 – $18,000 and takes three to six days from demolition to the final sweep of joint sand. The number depends on square footage, how much base has to be rebuilt on a sloped or long private approach, and the paver grade you pick. Call (888) 419-3650 and we’ll walk the driveway with you and put the range in writing before any work starts.

The Paver Driveways process, stage by stage
Most contractors describe paver work as “prep and install,” which tells you nothing. Here’s the actual sequence, with what you decide and when.
Day 1 – site walk and layout. Before demolition we mark utilities through the 811 service, check grade and drainage away from the garage, and stake the edges. On Alamo estate parcels with long approaches, this is also where we confirm the transition from county road apron to private drive. You decide edge restraint style and whether the drive ties into an existing walkway or stands alone. Roughly half a day.
Day 1-2 – demolition and excavation. Old asphalt, failing concrete, or the previous paver field comes out, then we excavate to depth. Paver drives need a base roughly twice the thickness of the pavers themselves, so a 2 3/8″ paver sits on 6″ to 8″ of compacted aggregate base, more on soft ground. This is the stage that surprises homeowners who expected a shorter job: the base, not the pavers, is where driveways fail. One to two days depending on square footage and haul-off.
Day 2-3 – base, compaction, and drainage. Aggregate goes in lifts, each compacted before the next goes down, and we check slope with a level at every lift. If the drive needs a channel drain at the garage threshold or a swale to move water off the hillside, it goes in now. You decide whether to add a drain and where. This is also when a county inspector may review if grading or drainage structures are part of the scope.
Day 3-5 – laying the field, borders, and cuts. Pavers go down in the pattern you chose, with a soldier course or border if you want one, and cuts at edges, curves, and the apron. It’s the most visible stage and the one most homeowners watch. Weather matters: we don’t set pavers in standing water, so a mid-project rain pushes the schedule.
Day 5-6 – joint sand, compaction, and cleanup. Polymeric or regular joint sand goes in, we run a plate compactor over the finished field, sweep, and haul off debris. You get a walkthrough and care instructions. We don’t leave until the drive drains where it’s supposed to.
This job is part of a full Driveway & Pavers in Alamo project whenever the paver drive connects to walkways, aprons, or a motor court, and we scope all of it together so the grades match.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
- Concrete pavers (the standard choice). Interlocking units in a range of colors and shapes, rated for vehicle loads. Honest trade-off: they cost more than asphalt up front but you can pull and reset a damaged section instead of patching. Best for homeowners who plan to stay.
- Clay brick pavers. Warmer look, holds color well, handles heat. Trade-off: higher material cost and a smaller selection of load-rated profiles. Suits the Mediterranean and ranch estates common in Alamo.
- Permeable pavers. Open joints and a gravel base that let water through. Trade-off: real drainage benefit on clay-heavy hillside lots, but they need periodic vacuuming to keep the joints open.
- Base depth and reinforcement. Standard 6″ base vs. 8″ or more with geotextile fabric on soft or sloped ground. The cost goes up, but so does the life of the drive.
- Pattern and border. Running bond, herringbone, or basketweave, with or without a contrasting border course. Herringbone interlocks best for driveways; a border adds cost and definition.
- Edge restraint. Plastic or aluminum edge pinning the field. You don’t want to skip this; it’s cheap insurance against spreading.
Brands like Belgard make paver lines that hold up well to vehicle traffic and heat, and we’ll show you samples on site so you can compare color against your house, not a catalog photo.
What Paver Driveways costs in Alamo, CA
Expect $7,000 – $18,000 for a paver driveway in Alamo. Here’s what pushes a job toward the low or high end.

- Square footage and approach length. A two-car pad sits near the low end; a long private drive to a hillside estate climbs toward the top.
- Existing condition. Solid subgrade is cheaper. Soft clay, old failed base, or buried debris means more excavation and haul-off.
- Slope and drainage. Hillside driveways off Stone Valley Road and similar grades need retaining, drainage, and sometimes geotechnical review, all of which add cost.
- Paver grade and pattern. Standard concrete pavers vs. clay brick or permeable units, plus borders and complex patterns.
- Permit and inspection scope. Straight paver replacement on the same footprint usually doesn’t need a permit. New grade changes, drainage structures, or a widened approach that touches the county road apron can.
A written estimate from us is line-item: base depth, paver type, drainage, and haul-off are all spelled out, and the number you see is the number you pay. What’s typically not included: unexpected underground utilities, major retaining work discovered after excavation, and landscaping repair outside the drive footprint. We flag those before we start, not after.
See the difference
Before
After
Before
After
Before
AfterWhat Alamo homes specifically do to this job
Alamo is unincorporated, so paver driveway work here usually runs through Contra Costa County rather than a city building department, and that changes the paperwork. On larger parcels in 94507, especially the custom ranch and Mediterranean estates with long drives and detached guest houses or outbuildings, the trigger for county review is often the grading and drainage rather than the pavers themselves. Hillside lots commonly deal with the county building and fire departments together, and slope work can bring geotechnical review a flat-lot job would never see.
The failure modes we find here are consistent. Long private drives built in the 1970s and 1980s have often lost their base to winter rain on clay-heavy soil, so the old surface looks fine until it dips at the garage apron. The San Ramon Valley’s hot, dry summers also age old asphalt and concrete, which is a big reason homeowners switch to pavers. And because much of the work is on large lots rather than tract infill, drive width, turnaround space, and where water leaves the property matter more here than they would on a typical suburban lot. We cover Alamo fully, from the valley floor up to the hillside estates, and homeowners often pair a new drive with ADU Design & Permitting in Alamo or Garage Conversion ADU in Alamo when the access and parking need to change with the build.
Serving Alamo, CA – Our Local Coverage Area
We serve Alamo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Paver Driveways in Alamo
Plan on three to six working days from demolition to cleanup for a typical residential drive. Long approaches, heavy excavation, or winter rain can stretch it. Call (888) 419-3650 and we’ll give you a real timeline after we see the site.
Replacing a driveway on the same footprint usually doesn’t require one. New grade changes, drainage structures, or work that touches the county road apron can. Because Alamo is unincorporated, that permit comes from Contra Costa County, and we handle the submittal and inspection where it applies.
Yes – most paver drives go in over the existing footprint with utilities marked and left in place. If excavation turns up a problem line, we stop and talk it through before doing anything that changes the scope. That’s part of our upfront pricing, no-surprises approach.
Most residential jobs land between $7,000 and $18,000, driven by square footage, base condition, slope, and paver grade. Call (888) 419-3650 for a free estimate – it’s line-item and free.
Every paver driveway we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. Our technicians have up to 12 years of experience, and we back the work in writing, not with a handshake.
Get a free paver driveway estimate in Alamo
Call (888) 419-3650 and a live person answers, any hour, any day – no voicemail. We’ll set a time to walk your drive, measure the approach, talk through paver options, and hand you a written, upfront estimate for Paver Driveways in Alamo. No guesses, no surprises. It’s free, and it’s the only way to know what your driveway will actually cost.
Written by the team at Groundwork Construction Co.