Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Backsplash, Tile & Flooring in Livermore, CA: Costs and Timelines
Backsplash, tile & flooring work in Livermore typically runs $800 – $2,500 for a kitchen backsplash and $2,000 – $6,500 for floor tile, with full backsplash-plus-flooring packages landing inside our $14,000 – $45,000 kitchen range when cabinets or counters are involved. A backsplash alone is usually a two-day job. Call (888) 419-3650 for a free on-site estimate.

How a Groundwork Backsplash, Tile & Flooring Job Runs, Stage by Stage
Most contractors treat tile as one bucket. It isn’t. The sequence below is the one we run on Livermore jobs, and it’s built around getting the job done right in a single trip out of the Valley.
Stage 1: Measure and layout (day 1, roughly 2 hours)
We template the wall, check every outlet and switch for level, and map where cuts will fall. This is where you decide tile size and pattern: a 3×12 subway run is forgiving of an old wall, while a 12×24 large-format layout demands a flatter substrate and more prep. Livermore homes with settled framing often need that conversation before a single tile is set.
Stage 2: Demo and substrate prep (day 1, 4 to 6 hours)
Old backsplash comes off, drywall or green board gets patched, and the wall is floated flat. Floor tile is a bigger lift: we pull the old material, check the subfloor for deflection with a straightedge, and screw down or level as needed. Clay-heavy soil under much of Livermore has done its work on plenty of slabs, so we check flat before we check pretty.
Stage 3: Layout check and dry-fit (day 1 end, 1 hour)
You walk the layout with us before thin-set goes up. This is your one clean chance to move a grout line or flip a herringbone direction; after this, changes cost money. It’s also when we confirm whether trim pieces, schluter, or bullnose go where.
Stage 4: Install and cure (days 2 to 3)
Tile goes up or down, cure time runs overnight, and grout comes the following day. Floor tile on a slab gets a little more cure buffer than a backsplash on drywall. We schedule inspection if the scope touches electrical or structural work.
Stage 5: Seal, caulk, walkthrough (day 3, 1 to 2 hours)
Grout gets sealed on natural stone and porous tile, caulk goes at every change of plane, and we walk the job with you under the 730-Day Done Right Promise. If a tile isn’t set right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Your Backsplash, Tile & Flooring Options, and What Each One Costs You
The materials list below is the honest version: what each option costs in Livermore, how it wears, and who it fits.
- Ceramic subway tile: The workhorse. Roughly $800 – $1,400 installed on a standard backsplash. Easy to clean, forgiving on older walls, and it doesn’t fight a busy countertop.
- Porcelain large-format (12×24 or bigger): About $1,400 – $2,500 for a backsplash. Fewer grout lines, modern look, but it needs a flat substrate and it’s less forgiving of a wall that’s out of plane.
- Natural stone (travertine, marble, slate): $1,800 – $2,500 and up. Beautiful and cool to the touch, but it wants sealing every year or two and it can stain.
- Luxury vinyl plank flooring: $2,000 – $4,500 for a typical kitchen. Warm underfoot, water-tolerant, fast install. It’s the sensible pick for a busy household that doesn’t want to baby a floor.
- Porcelain or ceramic floor tile: $2,500 – $6,500. Hard-wearing, easy to mop, cool in summer (which matters in Livermore). Needs a flat, deflection-checked subfloor.
- Natural stone flooring: $4,000 – $6,500+. The premium choice, with the same sealing upkeep as stone on the wall.
Pattern choice moves the number too. A straight lay is the base price; herringbone or a mosaic insert adds labor because every cut is a fussy one. Where the backsplash is set against a slab counter, we plan the caulk line at the counter first, because that joint is what tells you in two years whether it was done right.
What Backsplash, Tile & Flooring Costs in Livermore, CA
The short answer: a kitchen backsplash in Livermore runs $800 – $2,500, floor tile runs $2,000 – $6,500, and a combined backsplash-plus-flooring job typically lands between $3,000 and $8,000 before cabinets or counters enter the picture. When it sits inside a full kitchen scope, you’re looking at the $14,000 – $45,000 range.
Five things push a job from the low end to the high end:

- Square footage: A 30-square-foot backsplash is a day’s work; 200 square feet of floor tile is a multi-day job with a substrate check.
- Condition of what’s underneath: Settled framing or a cracked slab means prep we didn’t quote for if we didn’t see it on the walkthrough. This is the number-one variable.
- Material grade: Builder-grade ceramic and imported natural stone are on opposite ends of the same job.
- Moving plumbing or electrical: Adding an outlet under the counter, or relocating a sink line, changes the scope and may pull a permit.
- Pattern complexity: A straight subway run against a herringbone with a mosaic inlay.
Our written estimates are line-item and priced upfront; the number you see is the number you pay. We don’t do vague allowances. What’s typically not included: moving walls, re-wiring, or cabinet replacement, which are separate scopes. If you’re weighing tile against a broader remodel, it’s often part of a full Kitchen Remodeling in Livermore and we quote it that way.
See the difference
Before
After
Before
After
Before
AfterWhat Livermore Homes Do to a Backsplash, Tile & Flooring Job
Livermore sits directly on the Greenville Fault, and that reality surfaces in almost every tile job here. Downtown stock in 94550, the early-1900s Victorians and 1950s ranches, is where we see it most: cripple walls and unreinforced chimneys that predate any seismic code, and walls that have moved enough that a 12×24 large-format tile will telegraph the problem if we don’t float first. The city’s building department is strict, and a tile scope that touches framing or electrical often triggers a retrofit conversation we bring up early rather than late. The newer 1970s-90s tract homes in 94551 are a different story: more modern structural ties, fewer surprises, but clay-heavy soils and hot summers still cause slab movement and foundation cracks that find their way into floor tile. We see it on the flats near the edge of the Diablo Range foothills, especially where a slab has settled over a summer or two and grout lines start to spider. And the wildfire interface on that same edge keeps us thinking about fire-resistant materials where the scope allows.
Most of what we do here is one of two things: a backsplash refresh in a kitchen that’s otherwise sound, or a floor-tile repair from a slab that moved. Both benefit from getting it done in one trip out.
The homeowner who wants a bathroom refreshed at the same time often pairs this with Tub-to-Shower Conversion in Livermore, or updates fixtures and surfaces with Vanities, Tile & Fixtures in Livermore, so we quote the whole scope once. If you’re planning the wider project, our Kitchen Remodeling service covers it from one contractor. We handle this work across Livermore and the Valley, and we bring the material brands that work best for the job – whether that’s Belgard pavers for an outdoor kitchen surround or Techo-Bloc for a patio tied to the tile scope.
Serving Livermore, CA – Our Local Coverage Area
We serve Livermore and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Backsplash, Tile & Flooring in Livermore
A backsplash alone is typically two days: one for demo and prep, one for install and grout. Floor tile runs three to five days depending on square footage and cure time. A combined backsplash and floor job takes about a week, longer if the substrate needs repair.
Generally no, if the scope is a cosmetic tile and flooring replacement. A permit is typically required when you move plumbing, add or relocate electrical, or touch framing or structure, and given Livermore’s seismic requirements, that threshold is worth checking before demo starts. We pull and manage the permits as part of the scope so you don’t have to chase the building department.
Yes, and most of our Livermore jobs are exactly that. If you’re keeping your sink, outlets, and cabinet layout, backsplash and floor tile are straightforward cosmetic work with no structural change. If you want an outlet moved under the counter or a sink relocated, tell us at the walkthrough: that’s a permit item and we quote it upfront.
A kitchen backsplash runs $800 – $2,500; floor tile runs $2,000 – $6,500. A combined job typically lands between $3,000 and $8,000. Call (888) 419-3650 for an exact quote – estimates are free and line-item.
Every backsplash, tile & flooring project we do is backed by the 730-Day Done Right Promise. If a tile pops, a grout line cracks, or a joint wasn’t set right, we come back and make it right. That’s the guarantee, in writing, for the life of the promise.
Schedule a Free Backsplash, Tile & Flooring Estimate in Livermore
Call (888) 419-3650 to schedule a free on-site estimate for backsplash, tile & flooring in Livermore. A live person answers every call, 24 hours a day. We’ll walk the room, check the substrate, talk through material and pattern options, and leave you with a written line-item quote – no vague allowances, no change orders after the fact. Same scope, same number. $1,000 off projects over $10,000, with 0% financing for 18 months available.
Written by the team at Groundwork Construction Co.