Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Driveway Repair & Replacement in Alamo, CA: What It Takes and What It Costs
Driveway Repair & Replacement in Alamo usually means full removal and repour, because the long private driveways on estate lots here tend to be cracked through rather than surface-damaged. A typical replacement runs 2 to 4 days of work and lands between $5,000 and $14,000 for most residential drives, with paver driveways at $7,000 to $18,000. Call (888) 419-3650 and we’ll walk your driveway and give you a written line-item quote, free.

How the Work Actually Goes: Repair or Replacement, Stage by Stage
We don’t open with a truck and a demo hammer. The first thing we do is figure out whether you’re looking at a repair or a replacement, because in Alamo the answer is often decided by what’s underneath the slab, not by how bad the top looks.
Stage 1: Evaluation and layout (day 1, about 1 to 2 hours). We walk the drive, check for ponding, look at where water runs off toward the house, and probe the base. On hillside lots we’re also looking at whether the drive sits on fill or native soil, and whether a retaining structure is holding it. You decide here whether you want us to quote a repair or a full replacement. We give you both numbers so the choice is yours, not ours.
Stage 2: Demo and haul-off (day 1 or 2, 4 to 8 hours depending on square footage). Concrete comes out in sections and gets hauled to a recycler; asphalt is ground up. Long drives take longer, and gated estate entries with limited turnaround slow the haul. You decide on access: where trucks park, whether a gate code needs to change, and how long the drive needs to stay clear for daily use. We tell you up front that you’ll be parking on the street or the pad for a few days.
Stage 3: Base prep and grading (usually day 2, 3 to 6 hours). This is the stage almost nobody sees and the one that decides whether the new drive lasts. We re-grade for positive drainage away from the house, compact the base in lifts, and set form lines. If the existing base is failing, this is where the real fix happens. You approve the final grade and the slope before we pour.
Stage 4: Pour or lay, finish, and cure (day 3, plus cure time). Concrete gets placed, floated, and finished; pavers get set on a compacted base with edge restraint. Concrete needs to cure before you drive on it, so plan on keeping vehicles off it for several days. Pavers you can often walk on the same day. You pick the finish, joint, and color before this stage, not during.
Stage 5: Final walkthrough and warranty handoff. We check the grades, the joints, the edges, and the drainage path, and we put the workmanship coverage in writing. Any punch items get scheduled. This is the stage where a contractor either stands behind the job or disappears, and it’s the reason our work is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make: Materials and Specs, With Honest Trade-offs
Once the base is sound, the decision is what goes on top. Here’s how the options actually compare for a driveway in Alamo.
- Standard concrete ($4,500 – $12,000). The most common choice on Alamo estate drives. Broom finish, control joints, and a solid base get you 20-plus years. The trade-off is cracking: if the base moves or the joints are spaced wrong, you’ll see it. It’s also the least forgiving if you change your mind later.
- Pavers ($7,000 – $18,000). Highest upfront cost, but the best long-term story on hillside lots. If a section settles, you lift and reset that section instead of tearing out the whole drive. Belgard is a name we work with often. The trade-off is cost and the need for a properly compacted base; pavers on a bad base are just expensive gravel.
- Asphalt ($3,500 – $9,000). Cheapest per square foot and fastest to install. It handles the seasonal ground movement on clay-heavy slopes better than rigid concrete in some cases. The trade-off is longevity: expect resealing every few years and a shorter total life than concrete or pavers.
- Repair-only options. Crack routing and fill, slab replacement in sections, or mudjacking a settled panel. Cheaper and faster, and the right call if the base is still holding. The honest limit is that patching a drive whose base has failed just buys you a season or two before you replace it anyway.
We put real product and material options in front of you so you’re choosing quality, not just whatever’s on the lot that week.
What Driveway Repair & Replacement Costs in Alamo, CA
Most full replacements in Alamo land between $5,000 and $14,000. A targeted repair, like a few cracked panels or a settled section, runs a fraction of that. Five things push a job toward the low or high end:

- Square footage and length. Estate lots here have long private drives. A 40-foot drive and a 200-foot drive are not the same job, and the footage drives the number more than anything else.
- Existing condition and base. If the base is failing or the drive sits on uncompacted fill, we’re rebuilding layers nobody planned on. That’s where a “simple repour” turns into a real project.
- Grading and drainage work. Re-grading for runoff away from the house, adding a swale, or tying into a drainage system adds cost but is often the difference between a drive that lasts and one that ponds and cracks again.
- Material grade. Asphalt at the low end, standard concrete in the middle, pavers at the top. Same footprint, very different number.
- Permit and review scope. On hillside lots that trigger geotechnical review, the engineering and inspection side adds both time and cost.
Your written estimate is line-itemed: demo, haul-off, base prep, material, finish, and any drainage or structural work. What’s typically not included is landscape repair where equipment crosses a lawn, or changes you make after the pour is scheduled. No-hassle upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Alamo Homes Specifically Do to This Job
Alamo is unincorporated, so driveway and access work here runs through Contra Costa County’s building department rather than a city hall, and that changes the paperwork and the inspection path. The housing stock is custom ranch and Mediterranean estates built from the 1950s through the 2000s on half-acre to several-acre parcels, many with long private driveways, detached guest houses, and older outbuildings. Driveways on these lots fail in predictable ways: decades-old slabs crack along control joints that were spaced too far apart, hillside drives settle on clay-heavy soil after winter rains, and older access roads weren’t built for the weight of modern trucks and equipment. The San Ramon Valley’s hot, dry summers and seasonal Diablo winds also take a toll, drying and shrinking clay soils that then swell when the rains return. On hillside properties near Stone Valley Road, slope and drainage review often comes into play in a way a flat-lot job down in Walnut Creek never would.
Homeowners here also often pair drive and access work with other projects on the same lot: an ADU Site Prep & Utilities in Alamo job, where the drive has to carry equipment access to the build site, or a Junior ADU & Interior Conversion in Alamo where a new unit needs a proper path to the street.
Serving Alamo, CA – Our Local Coverage Area
We serve Alamo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Driveway Repair & Replacement in Alamo
A full replacement typically takes 2 to 4 days of construction, then several days of cure time before you drive on concrete. Long estate drives, gated entries, and hillside grading push it toward the longer end. Call (888) 419-3650 for a timeline specific to your drive.
Often yes, because Alamo is unincorporated and work runs through Contra Costa County, and hillside lots can trigger slope and drainage review. We handle the permit and inspection process for you. The scope of your drive determines exactly what’s required, and we confirm that before work starts.
Yes, if the underlying base is still sound. Section replacement, crack repair, and leveling are all options. If the base has failed, a patch won’t last and we’ll tell you so plainly rather than sell you a repair that returns next spring.
Replacement runs $5,000 to $14,000 for most residential drives, pavers $7,000 to $18,000, and asphalt $3,500 to $9,000. Targeted repairs cost far less. Call (888) 419-3650 and we’ll give you an exact written quote after walking the property, free.
Yes, all of it is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing.
Get a Free Estimate on Your Alamo Driveway
If your drive is cracked, settled, or past its service life, a free on-site estimate is the fastest way to know whether you’re looking at a repair or a replacement. We’ll walk the property, check the base and drainage, and leave you with a written line-item quote. Call (888) 419-3650 to schedule, and a live person answers day or night.
Written by the team at Groundwork Construction Co.