Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sliding & Patio Doors in Concord, CA: What the Job Actually Involves
Replacing a sliding or patio door in Concord typically runs $3,200 to $9,500 installed, and most single-door swaps are finished in one to two days. That covers removal of the old unit, framing and water-seal prep, the new door system, and a finished interior trim. French doors with dual operable panels, wider openings, or a new structural header push the number higher. Call (888) 419-3650 for a free on-site estimate before you commit to a spec.

The Stage-by-Stage Process for a Door Replacement
Sliding and patio door work is more precise than it looks, and the sequence matters as much as the product. Here’s what actually happens across a typical Concord job.
Stage 1: Measure and site assessment (day 1, 60 to 90 minutes)
We measure the rough opening, check the wall for square and plumb, and look at what’s behind the existing door: framing, header condition, and whether the threshold drains correctly. This is where you decide door style, glass package, and which way it slides or swings. On older Concord homes we also confirm the wall isn’t load-bearing in a way that changes the header plan.
Stage 2: Permit pull and product order (days 1 to 10)
Replacement doors in the same opening often qualify for an over-the-counter permit in Contra Costa County, but we confirm that before ordering anything. Lead times on custom sizes run two to six weeks; standard sizes are usually faster. You’ll sign off on the final spec sheet once the permit is issued.
Stage 3: Demo and opening prep (day 1 of install, 3 to 5 hours)
Out comes the old door, frame, and threshold. We inspect the framing for rot, shim the opening true, and install new flashing and a sill pan so water has somewhere to go. On older tract homes this is where we find the surprises: soft framing, missing house wrap, or a threshold pitched the wrong way.
Stage 4: Door set and seal (day 1 to 2, 4 to 6 hours)
The new unit gets set, shimmed, and plumbed to within a hair, then sealed at the exterior with flashing tape and a proper sill detail. We hang the panels, adjust the rollers or hinges, and test the lock and screen. Glass goes in last so it doesn’t get damaged during setting.
Stage 5: Interior finish, inspection, and walk-through (day 2 to 3)
Trim, caulk, and touch-up paint finish the interior side. The city inspection happens after the door is set and sealed, then we walk the job with you, demonstrate the lock and screen, and hand over the warranty paperwork. You approve the finished product before we pack up.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decision-making happens in the first conversation. Here’s what actually separates one job from another.
- Frame material. Vinyl is the value pick, mid-range on price, and holds up well in Concord’s dry summers. Fiberglass costs more but takes paint and handles heat swings without warping. Wood looks beautiful and needs the most upkeep in this climate.
- Glass package. Dual-pane low-E is the standard now and keeps summer heat out. Triple-pane is available but rarely worth it here. If the door faces afternoon sun, we recommend a solar-control coating.
- Sliding vs. French. Sliders save floor space and are simpler to seal. French doors open wider and look better but cost 20 to 40 percent more once you account for the framing.
- Configuration. Two-panel, three-panel, multi-slide, or fixed-plus-operable. Wider openings need structural review and add cost.
- Hardware and screens. Standard locks and retractable screens are included. Upgraded hardware and pet doors add modest cost.
What Sliding & Patio Doors Cost in Concord, CA
A single sliding patio door replacement in Concord runs $3,200 to $6,800 installed. A French door pair with framing work lands between $4,500 and $9,500. Multi-slide and wide-opening systems run $9,000 to $18,000 or more once structural work is involved. Here’s what pushes a job toward the low or high end.

| Factor | Effect on price |
|---|---|
| Single vs. double door | Double adds $1,500 to $3,500 |
| Standard vs. custom size | Custom adds $800 to $2,500 |
| Same opening vs. new opening | New opening adds $2,000 to $5,000 |
| Frame material | Vinyl is baseline; fiberglass and wood add 15 to 35 percent |
| Structural header change | $1,200 to $4,000 |
| Permit and inspection | Included in our written quote |
Every written estimate itemizes the door, glass, trim, flashing, permit, and labor. What usually isn’t included: interior drywall repair beyond small patches, exterior siding replacement if the opening changes, and finish painting.
See the difference
Before
After
Before
After
Before
AfterWhat Concord Homes Specifically Do to This Job
Concord’s older housing stock shapes this work more than the product catalog does. In the mid-century ranch tracts and the post-war single-story homes across ZIP codes 94519, 94522, 94524, and 94529, we routinely open a wall around a patio door and find framing that was never flashed the way modern practice requires, or a threshold that’s been quietly pulling water under the sill for years. That’s not a surprise in a home from the 1950s and 60s; it’s the reason we budget inspection time on the first visit. The valley-to-foothill gradient across Mount Diablo’s western slopes also means the door on the fog-cooled side of town faces different moisture pressure than the sun-baked uphill side, which changes our sealant and flashing recommendation. And in the older tracts, we regularly find unpermitted additions and shallow-pitch rooflines nearby, so before we touch a patio door we confirm the wall detail and drainage are actually working. If you’re already planning exterior work, homeowners often pair a door replacement with Windows & Doors in Concord as a single scope.
Serving Concord, CA – Our Local Coverage Area
We serve Concord and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Sliding & Patio Doors in Concord
A standard replacement takes one to two days on site, plus two to six weeks of product lead time if it’s a custom size. Permit issuance adds a few days for over-the-counter reviews. Call (888) 419-3650 for a scheduling estimate based on your door spec.
Yes, most sliding and patio door replacements in Concord require a permit, and an inspection follows installation. We pull the permit and handle the inspection as part of every job. Call (888) 419-3650 to confirm the permit scope for your door.
Yes, when the new door fits the existing rough opening. If you want a wider opening, French doors instead of a slider, or to relocate the door, structural framing changes are needed and add cost and time. Call (888) 419-3650 for a site assessment of what’s actually behind your wall.
Sliding doors run $3,200 to $6,800 installed, and French doors run $4,500 to $9,500 with framing work. Wide-opening and multi-slide systems start at $9,000. Call (888) 419-3650 for a line-item exact quote – estimates are free.
Yes, workmanship on every job is backed by the 730-Day Done Right Promise. If the installation isn’t right, we come back and make it right. Call (888) 419-3650 and we’ll walk you through what the promise covers.
Get a Free Sliding & Patio Doors Estimate in Concord
Replacing a sliding or patio door is a one- or two-day job with a real payoff: a sealed, quiet door that keeps Concord’s summer heat out and winter rain where it belongs. Call (888) 419-3650 for a free on-site estimate. We’ll measure, walk the wall, and hand you a written quote itemizing the door, glass, permit, and labor. If exterior work is part of the plan, the team also covers Windows & Doors across Concord, and homeowners often pair this job with Fence Repair in Concord or Paver Driveways in Concord for a single, coordinated scope.
Written by the team at Groundwork Construction Co.