Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Rio Vista, CA: What It Takes and What It Costs
A tub-to-shower conversion in Rio Vista typically runs $3,500 to $10,000 and takes five to eight working days from demo to final tile. The job means removing the existing tub, reworking the drain and valve rough-in to shower height, waterproofing the walls and floor, setting a new pan or tiled base, and hanging glass. For an exact number on your bathroom, call (888) 419-3650 and we’ll set up a free on-site estimate.

How the Conversion Actually Runs, Day by Day
Most contractors give you a start date and a shrug. Here’s the sequence we hold ourselves to, so you know what’s happening in your house and when you’ll have a working shower again.
Day 1: Demo and inspection
We pull the tub, cut back the surround to studs, and expose the drain and mixing valve. This is the day surprises surface: soft subfloor, corroded galvanized drain lines, or a valve that’s been weeping behind the wall for a decade. You get a written finding before we go further. On a typical Rio Vista conversion this runs one full day.
Day 2: Rough-in plumbing and framing
The drain gets repositioned to a centered shower location, the valve gets raised to about 42 to 48 inches, and any blocking for grab bars or a bench goes in now, not later. If the valve is being replaced, this is the day. Rough-in inspection happens here if your permit requires one.
Day 3: Waterproofing
We build the sloped pan, then install a bonded waterproofing membrane over the walls and floor. Schluter’s Kerdi system is what we use most, because it bonds directly to the substrate and gives us a continuous waterproof layer rather than a painted-on coating that can fail at the corners. This stage cannot be rushed. It has to cure before tile.
Days 4 and 5: Tile and grout
Wall and floor tile go up, then grout and sealant. You’ll choose tile, trim, and a niche layout at the estimate, not mid-job, because the layout drives where the framing blocking went on day 2. Most of our Rio Vista customers pick a 12×24 porcelain on the walls and a smaller format on the pan for grip.
Days 6 to 8: Fixtures, glass, and punch list
Showerhead, valve trim, drain cover, and glass panel or door go in. We run water, check the slope drains without pooling, and walk the job with you. Final inspection follows if the permit calls for it. Before you pick a version of this job, look at the wider scope of our bathroom remodeling service, because a conversion often makes sense bundled with the vanity or floor you were already planning.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change Your Result
You’re picking between real trade-offs here, not colors. Here’s what matters and what it costs you in the long run.
- Acrylic or fiberglass pan and surround: Fastest install, two to three days total, lowest price. It’s warm underfoot and easy to clean. It also has a lifespan, and the seams are where it fails first. Fits a rental or a second bathroom.
- Tiled shower with a bonded membrane: The default for a house you’re staying in. Deck mud pan or a foam pan, Schluter membrane, porcelain or ceramic tile. Built to be repaired tile by tile instead of replaced whole.
- Linear drain versus center drain: A linear drain lets you use a single larger-format floor tile and slopes in one direction. It costs more in material and labor, and it looks cleaner. A center drain is cheaper and easier to service.
- Frameless glass versus framed: Frameless glass, with hardware in a Grohe or similar finish, opens the room visually and is what most buyers expect now. It costs more and needs a final squeegee habit.
- Valve and trim quality: A Toto or Grohe valve and trim costs more up front and typically lasts far longer than builder-grade. This is buried behind the wall. Spend here.
- Bench, niche, and grab-bar blocking: All three need to be decided before the membrane goes on. Adding a bench later means tearing out waterproofing. Decide now.
What a Tub-to-Shower Conversion Costs in Rio Vista, CA
Expect $3,500 to $10,000 for the conversion in Rio Vista. The low end is an acrylic pan-and-surround replacement in a bathroom with sound plumbing. The high end is a fully tiled walk-in with frameless glass in a house where the drain, valve, and subfloor all need work.
Five things push the number:

- Size and layout: A standard 30×60 alcove is the budget case. A wider or longer footprint means more tile, more membrane, and often a custom pan.
- What’s behind the wall: Galvanized drain lines, a rotted subfloor, or a valve set in a shallow wall all add demo and repair days.
- Plumbing relocation: Centering the drain and raising the valve is normal scope. Moving the drain to the opposite end of the room is not, and adds both plumbing and framing.
- Material grade: Acrylic versus porcelain tile versus natural stone, plus the glass and trim you choose.
- Permit scope: A full replumb or structural change widens the permit and inspection requirement.
A written estimate from us lists demo, rough-in, waterproofing, tile, fixtures, glass, disposal, and permit line by line. Upfront pricing, no surprises: the number you see is the number you pay, unless you change the scope mid-job. What’s typically not included is moving a load-bearing wall, replacing the entire bathroom floor, or a vanity upgrade, each of which we’d quote separately.
See the difference
Before
After
Before
After
Before
AfterWhat Rio Vista Homes Specifically Do to This Job
Rio Vista sits where the Sacramento River meets the Delta, and the ground here is expansive clay with a high water table. That doesn’t sound like a bathroom problem until you open a wall on a slab-on-grade home and find the moisture that has been quietly working its way in at the slab edge. In the older Delta-era homes on raised foundations, that same moisture shows up as a spongy subfloor around the tub, which is the single most common repair we add during a conversion.
The Delta breeze keeps summers milder than the Valley but drives persistent afternoon wind, so exterior venting and window flashing get checked while the wall is open. In the newer subdivisions like Trilogy and Summerset, the tract-built stucco homes on slab need careful drainage detailing at the shower pan, because soft Delta ground and slab movement don’t forgive a poorly sloped pan. If this job is part of a full Bathroom Remodeling in Rio Vista, we sequence it so the conversion happens after any floor or subfloor work. Customers in town often pair this with Tile Roofing in Rio Vista or Metal Roofing in Rio Vista when the same wind-driven rain that finds slab edges is also finding the roof. We cover the whole Rio Vista area, ZIP 94571 included.
Serving Rio Vista, CA – Our Local Coverage Area
We serve Rio Vista and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Rio Vista
Plan on five to eight working days. Acrylic pan-and-surround jobs finish in two to three. Fully tiled showers with new rough-in take the full week or a bit more. Call (888) 419-3650 and we’ll give you a start-to-finish date at the estimate.
Yes, in most cases, because the drain and valve are being changed and that’s plumbing. Tile-only replacements on the walls without moving the drain may not need one. We pull the permit and schedule the inspection so you don’t have to; call for a scope check on your specific bathroom.
Usually, yes. A standard tub alcove is close enough in dimension that the drain can be recentered and the valve raised within the existing wall. Moving the drain to the opposite end, widening the alcove, or removing a wall is a different scope and a different price. Call (888) 419-3650 and we’ll tell you which category yours falls into.
Between $3,500 and $10,000 depending on pan type, tile grade, glass, and how much plumbing has to be replaced. A converted home in the $80K – $200K household range typically lands near the middle. Call (888) 419-3650 for an exact quote, and the estimate is free.
Every tub-to-shower conversion we do is covered by our 730-Day Done Right Promise. If the waterproofing, the pan slope, or the tile fails within two years, we make it right. Call (888) 419-3650 to get that in writing on your estimate.
Get a Free Estimate for Your Conversion
If you’ve been stepping over a tub you never use, we’ll come out, look at what’s behind the wall, and give you a written line-item estimate for the conversion. Calls are answered by a live person, 24/7. Financing and our $1,000 off projects over $10,000 are available. Call (888) 419-3650 to schedule.
Written by the team at Groundwork Construction Co.