Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Alamo: What It Costs and How Long It Takes
Walk-in showers & shower remodeling in Alamo typically run $9,000 – $28,000 for a full shower rebuild, and most projects finish in two to four weeks from demo to final inspection. The range is wide because the scope is: a simple curbless shower with stock tile sits near the bottom, while a frameless glass, bench seat, niche, and custom tile layout in a Stone Valley Road estate lands near the top. Call (888) 419-3650 for a free on-site estimate – upfront pricing, no surprises.

This page is about the shower itself, not the whole bathroom. If you’re also replacing the vanity, flooring, or lighting, that work belongs under Bathroom Remodeling in Alamo, and we scope both together so the plumbing and waterproofing are done once.
Key takeaways
- Most Alamo walk-in showers cost between $9,000 and $28,000, including materials, waterproofing, tile, glass, and permit.
- Expect two to four weeks on site, with roughly one full week dedicated to waterproofing and tile cure time.
- Contra Costa County (not a city building department) issues the permit, because Alamo is unincorporated.
- Frameless glass, custom tile patterns, and bench seats are the three biggest cost drivers.
How we build a walk-in shower: the real sequence
Every shower we build follows the same order. What changes is the size, the existing plumbing, and the finish level you choose. Here’s what actually happens, stage by stage.
Stage 1 – Site visit and measurements (day 1, about 90 minutes)
We measure the existing enclosure, check the drain location and slope, and look at what’s behind the old tile and backer. Older Alamo homes from the 1950s through the 1980s often have mud-set beds and galvanized or early copper drains, and that changes the plan. You decide rough layout here: shower footprint, bench or no bench, niche placement, and glass style.
Stage 2 – Permit and material selections (days 2 – 10)
We pull the shower permit from Contra Costa County and finalize your selections: tile, drain finish, valve trim, and glass. You’ll pick grout type (epoxy vs. cementitious), tile size, and whether you want a linear or center drain. Glass gets templated later, but we lock the opening dimensions now so the tile layout accounts for it.
Stage 3 – Demo and rough-in (days 10 – 12)
Demo takes one to two days. We remove the old enclosure, tile, and backer, then inspect the framing and subfloor for rot or water damage. If the drain needs to move or the valve is being upgraded, the plumber does that rough-in now, before any waterproofing. Rough inspection happens at this stage.
Stage 4 – Waterproofing and tile (days 12 – 20)
This is the stage that determines whether your shower lasts. We install a bonded waterproofing membrane over a sloped mortar bed, with the pan and walls sealed as one continuous system. Then tile goes up, and it cures. Cure time alone is three to five days depending on the setting materials – there’s no shortcut past it, which is why we don’t promise a one-week shower.
Stage 5 – Glass, trim, and final inspection (days 20 – 28)
Glass is templated after tile is set and installed once cure is complete. We set the trim, seal the seams, and walk through with you. The county inspector signs off on the final plumbing and the completed assembly. You get the inspection record and our 730-Day Done Right Promise in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
The price swing on a walk-in shower comes mostly from your material and glass choices, not the labor. Here’s what actually drives the decision.
- Tile size and format. Large-format porcelain (24×48 or bigger) reads high-end and reduces grout lines, but it costs more to set and requires a flatter substrate. Standard 12×24 porcelain is the workhorse: durable, easy to clean, half the installation complication.
- Glass enclosure. Frameless 3/8-inch tempered glass is the flagship look and the biggest single line item – it costs significantly more than a framed slider but opens up the shower visually. Semi-frameless is a middle option.
- Drain style. A center drain is standard and cheapest. A linear drain allows larger tile and a curbless entry, but adds cost and requires more careful slope work.
- Bench and niche. A built-in bench and recessed niche add framing and waterproofing detail, but they’re what most Alamo homeowners want in a primary shower.
- Fixtures and finish. Delta, Moen, and Kohler all have lines that hold up; brushed nickel and matte black are the current finishes. Trim is a modest line item compared to tile and glass.
What Walk-In Showers & Shower Remodeling costs in Alamo, CA
Walk-in shower installation in Alamo runs $4,500 – $12,000 for a straightforward replacement, and full shower remodeling with layout changes or a curbless conversion runs $9,000 – $28,000. Those numbers include permit, waterproofing, tile, glass, and labor.

| Line item | Typical range |
|---|---|
| Shower replacement (same footprint) | $3,000 – $8,500 |
| Walk-in shower installation | $4,500 – $12,000 |
| Full shower remodel with layout changes | $9,000 – $28,000 |
What pushes a job toward the low end: same footprint, standard 12×24 tile, framed glass, center drain, plumbing stays put. What pushes it up: relocating the drain or valve, curbless conversion requiring floor framing work, large-format or custom tile, frameless glass, and structural changes like widening the opening. Permit scope matters too – a shower-only permit is cheaper than a shower pulled inside a larger bathroom permit.
What’s in the written estimate: demo, waterproofing, tile, glass, trim, disposal, and permit. What’s not always included: structural repair if we find rot behind the walls, and any fixture upgrades beyond the allowance. We call those out before starting so there are no change orders. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Alamo’s estate lots do to this job
Alamo is unincorporated, so every shower permit goes through Contra Costa County building and fire departments rather than a city hall. That matters for scheduling – county review runs differently than Walnut Creek or Danville. On hillside parcels off roads like Stone Valley Road, plumbing changes that touch the waste line can trigger additional review, and older custom homes sometimes have well-and-septic systems where the drain path needs checking before we cut. We also find failure modes tied to the housing stock: 1970s and 1980s mud-set pans that were waterproofed with a copper liner and have reached the end of their life, and tile that was set directly to drywall in earlier remodels. Water quality in the valley is moderately hard, which means glass and showerheads scale faster than coastal homes – a reason many Alamo homeowners pair a shower rebuild with a softener loop. Homeowners often pair interior work like this with exterior projects; our Roof Replacement & Installation in Alamo and Metal Roofing in Alamo teams work the same estates, and some homeowners schedule both while scaffolding is up.
Serving Alamo, CA – Our Local Coverage Area
We serve Alamo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked about walk-in showers in Alamo
Most walk-in shower remodels take two to four weeks from demo to final inspection. Waterproofing and tile cure time make up roughly a week of that, and it can’t be rushed. Call (888) 419-3650 for a timeline specific to your shower.
Yes. Shower replacements and layout changes require a permit from Contra Costa County, since Alamo is unincorporated. We pull the permit and handle the inspection – it’s part of the written price, not a surprise add-on. Call us for a free estimate.
Yes, if the drain and valve stay in place, cost and timeline both drop. Keeping the same footprint with new waterproofing, tile, and glass is the most common approach we do in Alamo. If you want a curbless entry or a bench, that may require drain relocation – we’ll tell you upfront.
A frameless glass shower typically adds several thousand dollars to the project total, since the glass is tempered, custom-cut, and installed as a separate line item. The full project still lands within the $9,000 – $28,000 range for most Alamo homes. Call (888) 419-3650 for a line-item quote.
Every shower we build is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship on the waterproofing, tile, and installation. Call us to schedule your free estimate and we’ll walk through the details.
Get a free estimate on your Alamo shower
We’ll come to your Alamo home, measure the existing shower, look at what’s behind the walls, and give you a written line-item estimate with no hidden numbers. Our technicians have up to 12 years of experience on shower builds and waterproofing. We cover Alamo and the surrounding valley, and our Bathroom Remodeling team handles anything beyond the shower itself. Call (888) 419-3650 – a live person answers, and we’ll get you scheduled.
Written by the team at Groundwork Construction Co.